1. Chip Configuration and Drivers – Status Report
Group Members:
Tyler Doering
Garrett Chandler
Taye Gebrewold
Current Status:
SWUART has been completed and tested
Clocks for system and all hardware have been set up
OS_timer has been set up
All the timers and hardware have been selected

2. Chip Configuration and Drivers – Hardware Map
Timer A : TMRA3
19200 Hz interrupts (4800 baud generation at 4x for signal pseudo-sync)
Software UART Receive
1200 Hz interrupts (1200 baud generation for signal pseudo-sync)
Software UART Transmit
Timer B : TMRB7
8000 Hz interrupts
Analog Audio
100 Hz interrupts
OS Tick
Sensor Acquisition
Analog to Digital Converter : ADC12
Analog audio in
8 bit samples
Digital to Analog Converter : DAC12
Analog audio out
Port Interrupts
Software UART Receive Sync
DTMF Valid Signal
Supervisor Serial Interface (Currently Undefined)
Receiver/Transmitter Zero : USART0
UART
Camera at [ | | 9600 ] baud (others available)
SPI
SD Flash Mass Storage (Unknown max flash speed. Test at uC max and backoff as necessary.)
I2C
Speed
400khz by spec. Drive at [ 200k | 100k | 50k ].
Devices
Camera Temperature
Radio TX/RX/AMP Binary Power Control
Radio TX Current
Radio RX Current
Power System
Receiver/Transmitter One : USART1
MHX [ | | 9600 | 1200 ]