1. Alyssa Byers, Dalton Brooks, and Justin Brister
The Shot List
Alyssa Byers, Dalton Brooks, and Justin Brister

2. This is the question that your experiment answers
Ninhydrin & Acetone

3. Ninhydrin & Acetone cont.

4. Process Porous material (paper) and a light colored surface
Spray on Ninhydrin & Acetone
Allow to dry
Place between a paper towel
With a steam iron the fingerprint will process a dark purple color
The steam is added to accelerate the drying process
Summarize your research in three to five points.

5. White Wet Wop & Black Electrical Tape
This is the question that your experiment answers
White Wet Wop & Black Electrical Tape

6. White Wet Wop & Black Electrical Tape

7. Process
Adhesive material (black electrical tape) with a dark colored surface
Paint on
Wait ten seconds
And then rinse off material with water
The fingerprint will show up white on a dark colored surface
Summarize your research in three to five points.

8. This is the question that your experiment answers
Rhodamine 6G

9. Rhodamine 6G cont.

10. Process Non-Porous material (Bong) Recommended light 495-540nm
Orange or Red filter used to block light
Spray on
Allow to dry
View underneath an alternative light source
In the photo 515nm was used with an orange filter
Summarize your research in three to five points.

11. Amido Black & Ninhydrin Acetone
This is the question that your experiment answers
Amido Black & Ninhydrin Acetone

12. Ninhydrin & Acetone

13. Process Blood print on Porous material (Drywall) Spray on Let dry
Steam Iron with a paper towel placed over material
Summarize your research in three to five points.

14. Amido Black

15. Process Blood print on Porous material (Drywall) Spray on
Rinse Immediately with water
Allow to dry
Prints will process as a black/blue color
Summarize your research in three to five points.

16. Black Magnetic Powder & Regular Black Fingerprint Powder
This is the question that your experiment answers
Black Magnetic Powder & Regular Black Fingerprint Powder

17. Black Magnetic Powder

18. Process Black magnetic powder on non-porous material
Brush in circles over print
Remove excess with wand and rocket
Lift print with clear lifting tape
Place tape on white index card
Print will process black on a white surface
Summarize your research in three to five points.

19. Regular Black Fingerprint Powder

20. Process Regular Black Fingerprint Powder on non- porous material
Brush in circles over print
Remove excess with rocket blower
Lift print with clear lifting print
Place tape on white index card
The print will process black on a white background
Summarize your research in three to five points.

21. “I Killed Your Dog”

22. “I Killed Your Dog”

23. Process The duct tape was removed using the air duster
Black Wet Wop was used to on the adhesive side of the duct tape
The duct tape was fumed in a Styrofoam cup
Black magnetic powder was used on the non-adhesive side of the duct tape
Ninhydrin & Heptane was used to develop all of the prints on the piece of paper
Summarize your research in three to five points.

24. Summarize your research in three to five points.