1. TIRE BALANCING

2. WEAR YOUR SAFTY GLASSES!!!
Tire Balancing

3. KNOW YOUR TOOLS
TIRE WIDTH CALIPER
WEIGHT HAMMER

4. Select Proper Inner Alignment Cone

5. PUT TIRE ON MACHINE

6. Carefully Place Wheel Onto Balancer Quill Shaft

7. Slide Wheel Fully Up Onto Inner Cone

8. Use Hub Nut (spinner) to Tighten Wheel onto the Balancer Quill

9. MEASURE TIRE WIDTH WITH CALIPER

10. Determine “Away” Distance
Using Laser Arm

11. Determine “Diameter” From Tire Size Listing On Both Sides of Tire

12. Wheel Balancer DISPLAY SCREEN

13. Insert “W”idth, “D”iameter, & “ A”way Settings into Balancer Display

14. After you are done entering the width on the keypad then put the shield down and the machine will test the tire and give you the results.

15. Select to Correct Amount of Weight From the Sorting Tray

16. After the machine gives you the results put the correct amount of weight on both sides of the tire.

17. Align the Balance
Line As Shown,
Add the Amount
Of Weight Displayed
At the 12:00 Position
Of the Wheel.
The Final
Result Should
Be ‘Zeros’ in
the Left &
Right Plane
Displays

18. Remove the Finished Wheel From the Balancer, Put Away All Weights &
Weight-Tools, Fill-Out Task Sheet With Required Info
CLEAN UP AFTER YOURSELVES. TAKE CARE OF YOUR WORK SPACE