1. Dash panel insert - Gateway-

2. Battery voltage display
Dash panel insert
Warning lamps
Display for drive relevant functions
Display for comfort and chassis functions
Coolant temperature
Fuel gauge
Battery voltage display
Oil temperature
Display for infotainment functions

3. Equivalent parts System part D-class combi version‘s in VW Touareg
- Porsche Cayenne
- Bentley BY 6xx
Equivalent parts
Platine main board 100 % identical
Software 80 %
Back side 100%
Different front frames (Design)

4. Dash panel insert

5. Dash panel insert

6. Dash panel insert Multifunctional area e.g. fuel reserve
Area for „Soft“ LED
e.g. fuel reserve
Area for „Soft“ LED
area for gear lever position display
milage km
Dayli milage km
Outside temperature display

7. Area for YELLOW warning display‘s
Display TFT monitor
More then 100 Warning‘s and information‘s
possible in the center display
Multifunctional area
Area for YELLOW warning display‘s
Check dipped beam
Check tire pressure
Check water reservoir
Check...

8. area for YELLOW warning display‘s
Display TFT monitor
More then 100 Warning‘s and information‘s possible in the center display
Multifunctional area
Area for RED warning display‘s
area for YELLOW warning display‘s
Check dipped beam
Tire pressure
Check tire pressure
Coolant
Check water reservoir
Oil pressue
Check...
...

9. R1 R2 Fuel gauge V1 + V2 = V 35,0 Ltr. + 55,0 Ltr. = 90,0 Ltr. V1 V2
50-270
Tank
algo-rithm Vd V2 R2
angle
50-270
The 2 volumes V1-V2 are added to form volume V in the instrument cluster. This value and the 2 sub-volumes and resistances are output in instrument cluster self-diagnosis (17) Measured value block 2, 5 and 6

10. Tank display -fault diagnosis-
If a fault is diagnosed in at least one sender, the pointer goes to "zero" after approx. 20 sec. and no reserve check (soft LED) is displayed.
Fault memory: Short-circuit to ground, interruption, short-circuit to positive
Measured value block: 2
Tank volume V (non-damped) in litres
Tank display regardless of sender faults. If only 1 sender is OK, the residual volume is displayed, although the pointer is set to zero
Measured value block : 5
Resistance sender 1 Resistance sender 2
Measured value block : 6
Sub-volume 1 in L Sub-volume 2 in L

11. Comfort Infotainment Drive train Data diagnosis Gateway
Integrated CAN Data GATEway for transmission to CAN drive train – CAN comfort – CAN infotainment
Integrated Diagnosis Gateway (K-wire via CAN)
Communication with all CU‘s in the vehicle
Processing from approx. 600 CAN messages and 10 conventional interfaces
Comfort
Infotainment
Drive train

12. Drive train
Gateway CU
Comfort
Infotainment

13. Self diagnosis dash panel insert
CAN comfort 1. 2. 3. 4.
130
Single /
Double wire
Comfort
Door driver
Passenger door
131
Door rear left
Door rear right
Memory
Electrical central unit
132
Multifunction steering wheel
A/C
Tire pressure
133
Roof electric
Memory passenger
Parking
134
EIS
135
Trailer

14. Guided fault finding Address word:17 Instrument cluster
19 Gateway
Guided fault finding
Measured value blocks
Adaptation
Coding
Actuator diagnosis

15. Practice on the vehicle
Dash panel insert
Practice on the vehicle
Testing on the vehicle