1. Prepared by Debby Bloom-Hill CMA, CFM

2. Activity-Based Costing
CHAPTER 6
Cost Allocation
&
Activity-Based Costing

3. Purposes of Cost Allocation

4. Process of Cost Allocation
Cost allocation is achieved by a three step process:
Determine the cost objective.
Form cost pools.
Select an allocation base to relate cost pools to the cost objective.

5. Allocating Service Department Costs
Organizational units of manufacturing firms classified as either:
Production departments:
Engage in direct manufacturing activity.
Service departments:
Provide indirect support.
Cost pools:
Formed by service departments.
Allocated to production departments.

6. Direct Method of Allocating Service Department Costs
Service department costs allocated to production departments but not to other service departments:

7. Direct Method – Mason Furniture
Allocate janitorial cost of $100,000.
Allocation base: square feet
Assembly department: 20,000 square feet
Finishing department: 30,000 square feet
Calculate the allocation rate:
$100,000 / (20, ,000) = $2/sq ft
Allocation to production departments:
Assembly dept.:20,000 sq ft x $2 = $40,000
Finishing dept.: 30,000 sq ft x $2 = $60,000

8. Direct Method – Mason Furniture
Allocate personnel cost of $200,000.
Allocation base: number of employees.
Assembly department: 60 employees
Finishing department: 40 employees
Calculate the allocation rate:
$200,000 / ( ) = $2,000/employee
Allocation to Production Departments.
Assembly dept: 60 x $2,000 = $120,000
Finishing dept: 40 x $2,000 = $80,000

9. Direct Method – Mason Furniture

10. Allocating Budgeted and Actual Service Department Costs
Management should allocate based on budgeted rather than actual costs.
Allocation of actual amounts allows service department to pass on cost of inefficiencies and waste to production departments.

11. Problems with Cost Allocation
Potential problems are brought about by:
Allocations of costs that are not controllable.
Arbitrary allocations.
Allocation of fixed costs that make the fixed costs appear to be variable costs.
Allocations of manufacturing overhead to products using too few overhead cost pools.
Use of only volume-related allocation bases.

12. Activity-Based Costing (ABC)
Using the ABC approach, companies identify major activities that cause overhead costs to be incurred.
Some activities are related to production volume, some are not.
The cost of resources consumed performing these activities are grouped into cost pools.
Costs are assigned to products using a measure of activity referred to as a cost driver.

13. The ABC Approach

14. Common Activities and Associated Cost Drivers

15. Pros and Cons of ABC Pros:
Less likely to undercost complex low volume products and overcost simple high volume products.
Drivers used in ABC are not always volume related.
ABC may lead to improvements in cost control.
Costs are not buried in one or two pools.

16. Pros and Cons of ABC Cons:
More costly to develop and maintain than a traditional costing system.
Allocations are made from each cost pool to each product.
Used to develop full cost of products.
Includes fixed costs.
Lacks incremental information necessary for decision making.

17. Activity-Based Management

18. Copyright
© 2010 John Wiley & Sons, Inc. All rights reserved. Reproduction or translation of this work beyond that permitted in Section 117 of the United States Copyright Act without the express written permission of the copyright owner is unlawful. Request for further information should be addressed to the Permissions Department, John Wiley & Sons, Inc. The purchaser may make back-up copies for his/her own use only and not for distribution or resale. The Publisher assumes no responsibility for errors, omissions, or damages, caused by the use of these programs or from the use of the information contained herein.