1. Accredited Standards Committee C63® - EMC
Subcommittee 5 – Immunity
Report to Main C63® Committee
Stephen R Whitesell
Chair, SC5
November 12, 2016

2. Accredited Standards Committee C63® - EMC
Proposed SC5 Membership
Steve Whitesell – Chair Ed Hare – Vice Chair Jerry Ramie – Secretary
Poul Andersen Dan Hoolihan Masud Attayi Rick Lombardi Stephen Berger Randy Long Craig Fanning David Schaefer Andy Griffin Jeff Silberberg Don Heirman Dave Zimmerman

3. Accredited Standards Committee C63® - EMC
SC5 Scope
Subcommittee 5 is responsible for developing and maintaining new and existing standards for immunity testing techniques and associated instrumentation as requested by the Main Committee ANSI ASC C63®
(no change)

4. Accredited Standards Committee C63® - EMC
SC5 Duties
Subcommittee 5 is responsible for the development, maintenance, and revision, as appropriate, of the following documents:
C63.9 Immunity of Audio Office Equipment
C63.15 Immunity Measurement of Electrical and Electronic Equipment
C63.16 ESD Test Methodologies
C63.24 Generic In-Situ Immunity Testing

5. Accredited Standards Committee C63® - EMC
Motions
On behalf of SC5, I move that the Main Committee approve the membership, scope, and list of duties for the subcommittee as shown on the three previous slides.

6. Accredited Standards Committee C63® - EMC
SC5 Project Status
C63.9: Immunity of Audio Office Equipment
Chair: Andy Griffin
A PINS-C was approved in May 2015 and a small Working Group has been formed. Additional participants are encouraged. A proposed PINS was reviewed by SC5 on Tuesday and is being recommended for approval by the Main Committee.
Motion: On behalf of SC5, I move that the main committee approve the PINS for revising C63.9 as presented.

7. Accredited Standards Committee C63® - EMC
SC5 Project Status
C63.15: Immunity Measurement of Electrical and Electronic Equipment
Chair: Don Heirman
The Working Group has been very active in revising the document based on information in the PINS-C. Additions include automotive, quasi-static, proximity, and overhead power line testing. A proposed PINS was reviewed by SC5 on Tuesday and is being recommended for approval by the Main Committee.
Motion: On behalf of SC5, I move that the main committee approve the PINS for revising C63.15 as presented.

8. Accredited Standards Committee C63® - EMC
SC5 Project Status
C63.16: ESD Test Methodologies
Chair: Steve Whitesell
We received news near the end of the SC5 meeting on Tuesday that C63.16 has been published. My thanks to the WG members as listed below for their help in making this document a reality:
Tom Braxton Jerry Ramie Al Crum Jeff Silberberg Don Heirman Richard Worley Rick Lombardi

9. Accredited Standards Committee C63® - EMC
SC5 Project Status
C63.24: Generic In-Situ Immunity Testing
Chair: Don Heirman
Don has been in contact with Chad Kiger about working further development of this document as a joint project with the EMC Society’s revision of IEEE 473, which addresses site survey measurements of ambient RF signals. C63.24 is intended to address testing of equipment for immunity to those ambient signals. Concern was expressed that techniques used by IEEE 473 are out of date and will not give useful results. We await further input as to the feasibility of this joint project approach.