1. Chapter 29: Nuclear Physics
The Nucleus
Binding Energy
Radioactivity
Half-life
Biological Effects of Radiation
Induced Nuclear Reactions
Fission and Fusion

2. §29.1 Nuclear Structure
The atomic nucleus is composed of neutrons and protons. These particles are called nucleons.
Could incorporate personal response system questions from the College Physics by G/R/R 2E ARIS site ( Instructor Resources: CPS by eInstruction, Chapter 29, Questions 2, 3, and 12.
The atom’s atomic number (Z) gives the number of protons in its nucleus. It is the atomic number that determines an atom’s identity.

3. The nucleon number or mass number is A = Z+N, where N is the number of neutrons.
Masses of atoms are sometimes give in terms of atomic mass units. 1u = 10-27 kg.

4. Atoms of the same element with differing numbers of neutrons are known as isotopes.
The mass quoted for an atom in the periodic table is a weighted average over all of the natural isotopes of that element. The weight factors are determined by using the relative abundance on Earth of each isotope.

5. For an atomic nucleus
This implies the density of an atomic nucleus is independent of A.
As an equality
where r0=1.210-15 m = 1.2 fm

6. Example (text problem 29.2): Calculate the mass density of nuclear matter.
Consider a nucleus with one nucleon (A = 1).
The density is

7. Example (text problem 29.9): Find the radius and
volume of the nucleus.
The radius is
The volume is

8. §29.2 Binding Energy
A nucleus is held together by the strong nuclear force. This force only acts over distances of a few fermis.
Could incorporate personal response system questions from the College Physics by G/R/R 2E ARIS site ( Instructor Resources: CPS by eInstruction, Chapter 29, Question 4.

9. The binding energy (EB) of a nucleus is the energy that must be supplied to separate it into individual protons and neutrons.
EB = Total energy of Z protons and N neutrons – total energy of nucleus.

10. Total energy of Z protons and N neutrons = (mass of Z protons and N neutrons)c2.
Total energy of nucleus= (mass of nucleus)c2.
These can be used to define the mass defect m = (mass of Z protons and N neutrons) - (mass of nucleus) so that

12. Nucleons also obey the Pauli Exclusion Principle such that only two protons (neutrons) can occupy each proton (neutron) energy level.
Like an atom, a nucleus can be put into an excited state if it absorbs a photon of the correct energy. The nucleus can then emit a photon to go to a lower energy state.

14. Example (text problem 29.14): (a) Find the binding energy of the 16O nucleus.

15. (b) What is the average binding energy per nucleon?
Example continued:
(b) What is the average binding energy per nucleon?

16. §29.3 Radioactivity
Some nuclei are unstable and decay. These nuclei are radioactive. A nucleus can emit an alpha ray, beta ray, or a gamma ray during its decay.
Could incorporate personal response system questions from the College Physics by G/R/R 2E ARIS site ( Instructor Resources: CPS by eInstruction, Chapter 29, Questions 1, 5, 6, 7, 11, 13, 14, 6, 18, 19, and 20.

17. During nuclear reactions:
Charge is conserved.
The total number of nucleons is constant.
Energy is conserved.
Define: disintegration energy = binding energy of radioactive nucleus – total binding energy of products. This is the rest mass energy that can be converted into other forms of energy.

19. Alpha rays have been identified as helium nuclei.
The reaction for alpha decay is
Parent nucleus
Daughter nucleus
Alpha particle

20. Example (text problem 29.28): Show that the spontaneous alpha decay of 19O is not possible.
The reaction is
The mass of the products (including electrons) is u.
The mass of 19O is u.
The mass of the products is larger than the reactant, so this reaction cannot occur spontaneously.

21. Beta rays have been identified as either electrons (-) or positrons (+).
The reaction for beta-minus decay is
The reaction for beta-plus decay is

22. The neutrino and antineutrino have no charge and are nearly massless
The neutrino and antineutrino have no charge and are nearly massless. They do not readily interact with matter.

23. During beta-minus decays, a neutron is converted into a proton.
During beta-plus decays, a proton is converted into a neutron.

24. Example (text problem 29.29): Calculate the maximum kinetic energy of the beta particle when decays via - decay.
The reaction is
The maximum kinetic energy of the electron is given by the disintegration energy.

25. The difference between the mass of the products and the reactant is
Example continued:
The difference between the mass of the products and the reactant is
The disintegration energy and the maximum KE of the electron is

26. During inverse beta decay (electron capture) a proton in a nucleus captures an electron. The reaction is

27. Gamma rays were determined to be high energy photons.
A gamma ray will be emitted when a nucleus is an excited state when making a transition to a lower energy level. For example,
When a nucleus has experienced alpha or beta decay, it is not always left in the ground state.

28. §29.4 Radioactive Decay Rates and Half-Lives
The half-life of a sample of unstable nuclei is the time it takes for one-half of the sample to decay. The decay process is quantum mechanical and is based on probability.
Could incorporate personal response system questions from the College Physics by G/R/R 2E ARIS site ( Instructor Resources: CPS by eInstruction, Chapter 29, Questions 8, 9, 15, and 17.

29. Each radioactive nucleus has a probability per second that it will decay, called the decay constant.
The number of nuclei that decay in a short time interval is
There are statistical fluctuations in the number of decays that occur. These fluctuations are of order

30. The decay rate or activity is the number of radioactive decays that occur in a sample per unit time.
The unit of activity is the bequerel. 1 Bq = 1 decay/sec. Another common unit is the curie. 1 Ci = 3.71010 Bq.

31. The number of nuclei remaining in a sample having N0 nuclei at t=0 is
is the mean lifetime of a nucleus.
Note: the above expression for N(t) is a way to determine the number of remaining nuclei only. It does not tell us which nuclei have decayed.

32. The activity at time t is
where R0 is the activity at t=0.

33. It is common to write the expressions for N(t) and R(t) in terms of half-life (T1/2).

34. Example (text problem 29.37): Some bones discovered in a crypt in Guatemala are carbon dated. The 14C activity is measured to be Bq per gram of carbon. Approximately how old are the bones?
Solve for t:

35. §29.5 Biological Effects of Radiation
The absorbed dose of ionizing radiation is the amount of radiation energy absorbed per unit mass of tissue. Ionizing radiation is radiation with enough energy to ionize an atom or molecule.
The SI unit of absorbed dose is the Gray. 1 Gy = 1 J/kg. Another common unit is the rad (radiation absorbed dose). 1 rad = 0.01 Gy.

36. Different radiation causes different amounts of biological damage
Different radiation causes different amounts of biological damage. The biologically equivalent dose measures the amount of damage caused by radiation exposure.
Equivalent dose (in sieverts) = absorbed dose (in grays)* QF.
Equivalent dose (in rem) = absorbed dose (in rads)* QF.
QF is a quality factor that is a relative measure of biological damage (200 keV x-rays have QF = 1).

37. The sievert is the SI unit of biologically equivalent dose
The sievert is the SI unit of biologically equivalent dose. 1 Sv = 100 rem.

38. Alpha, beta, and gamma radiation penetrates to different depths in biological materials.
Alpha rays are stopped by a few cm of air or about 0.02 mm of aluminum.
Beta-minus can penetrate a few cm into biological tissue.
Gamma ray absorption is based on probability so they can penetrate to varying depths.

39. Example (text problem 29.45): An alpha particle produced in radioactive alpha decay has a kinetic energy of typically about 6 MeV. When an alpha particle passes through matter, it makes ionizing collisions with molecules, giving up some of its kinetic energy to supply the binding energy of the electron that is removed. If a typical ionization energy for a molecule in the body is around 20 eV, roughly how many molecules can the alpha particle ionize before coming to rest?

40. §29.6 Induced Nuclear Reactions
An unstable nucleus decays in a spontaneous nuclear reaction. An induced nuclear reaction only takes place because it is caused by a collision between a nucleus and another particle.

41. For example,
The above reaction is induced by the absorption of a neutron. This process is called neutron activation.
A spontaneous nuclear reaction will always release energy. In an induced nuclear reaction, some of the kinetic energy of the reactants is converted into rest mass of the products.

42. An exoergic reaction releases energy.
An endoergic reaction is one that requires energy to make it proceed.

43. Example (text problem 29. 49): A certain nuclide absorbs a neutron
Example (text problem 29.49): A certain nuclide absorbs a neutron. It then emits an electron, and then breaks up into two alpha particles. (a) Identify the original nucleus and the two intermediate nuclei (after absorbing the neutron and after emitting the electron).
The reactions are
Since the number of nucleons is conserved e = = 8. Charge is conserved so f = = 4. Identify X3 as Be.

44. The nuclei involved are
Example continued:
In the second step of the first reaction c= e+0 = 8 and d = f This gives d = 3. Identify X2 as Li.
In the first step of the reaction a + 1 = c so a = 7 and b + 0 = d = 3. Identify X1 as Li.
The nuclei involved are

45. (b) Would any (anti)neutrino(s) be emitted? Explain.
Example continued:
(b) Would any (anti)neutrino(s) be emitted? Explain.
In the second reaction (the beta decay of 8Li) will also involve the emission of one antineutrino.

46. §29.7 Fission
Fission is when a large nucleus splits into two smaller, more tightly bound nuclei. This process releases energy.
Fission can either occur spontaneously when the nucleus is very large, or it can be induced. When fission occurs by the capture of slow moving neutrons, a chain reaction can occur.

47. §29.8 Fusion
The process of fusion takes two small nuclei to form a larger nucleus.
Could incorporate personal response system questions from the College Physics by G/R/R 2E ARIS site ( Instructor Resources: CPS by eInstruction, Chapter 29, Question 10.

48. The process of fusion is the energy production mechanism in cores of stars. Stars on the main sequence (like the Sun) turn hydrogen into helium in their cores. This occurs by the proton-proton cycle and by the CNO (carbon) cycle.
Overall, this process take four protons and turn them into a helium nucleus and energy.

49. Example (text problem 29.57): Consider the fusion reaction between a proton and a deuteron (shown below). (a) Identify the reaction product X.
The product must have 3 nucleons and a charge (atomic number) of 2. The element is He.

50. Example continued:
(b) The binding energy of the deuteron is about 1.1 MeV per nucleon and the binding energy of “X” is about 2.6 MeV per nucleon. Approximately how much energy (in MeV) is released in this fusion reaction?
The binding energies are: 0 MeV for 1H; 2.2 MeV for 2H; and 7.8 MeV for 3He.
Energy released = difference in binding energy between the products and reactants = 7.8 MeV – 2.2 MeV = 5.6 MeV.

51. (c) Why is this reaction unlikely to occur at room temperature?
Example continued:
(c) Why is this reaction unlikely to occur at room temperature?
At room temperature the reactants will not have enough kinetic energy to overcome the Coulomb repulsion between them to get close enough to fuse.

52. Summary The Nucleus (atomic & mass numbers) Binding Energy
Radioactive Nuclei
Alpha, Beta, and Gamma Radiation
Half-life and Activity
Absorbed Dose
Spontaneous vs. Induced Nuclear Reactions
Fission vs. Fusion