1. Acer Agusta tear down SOP
Quanta CNBU ME team 2014/10/30 (EV1)

2. Preparation:
tools
Thin slice of plastic or guitar picks(0.5~0.7mm thickness)
Small tweezers
Phillips screwdrivers(#0)
Metal SIM pin or paperclip

3. Step 1:
Use metal SIM pin or paperclip stab into the SIM tray hole
insert
insert
Pull out the ejected tray

4. Step 2:
Use the sharp edge of plastic tool insert the gap between bottom case and LCD bezel.
insert
The insert point is at the middle area of volume and power key

5. Step 3:
Keep plastic slice steady, then push it counterclockwise until bottom case and LCD bezel have separated.
Forcing direction

6. Bottom case tear down completed

7. Step 4: Tear down the battery
Tear the yellow tapes out first, then separate the male and female battery connector, and then remove the battery.
Fast-remove-adhesive liner

8. First, separate the male
and female battery
connector.
Second, grab the liner of battery-fast-remove-adhesive and pull out.
Finally, the batter can be removed easily.

9. Step 5: Remove RF cable
Plug out the
connector
Plug out the
connector

10. Step 6: Remove speaker 連接器 Second, tear 2 screws down
and remove the speaker.
First, separate the male and
female power connector.
連接器

11. Step 7: Remove FPC
First, remove the FPC from zif connectors, two side by each one.
Second, remove both FPC, pull them
up against bezel.

12. Step 8: Remove sub PCBA Conductive adhesive between sub board
and bezel
Pull up from this edge

13. Step 8: Remove cameras Second, remove cameras
First, remove FPC from both zif connectors

14. Step 9: Remove the USB-metal-holder
screws
Remove 2 screws

15. Step 10: Remove main PCBA
Tear down 4 screws
Remove PCBA

16. Tear down completed