1. T3MAPS Summer Final Report
Yedi Luo & Raymond Mui

2. Introduction Control T3MAPS using Atlys card Set up: Goal:
Keep developing DAQ system for T3maps.
Column test
Analog Test

3. Progress Reading T3MAPS Manual FEI4 Manual T3MAPS python software code
Testing
Column test with multiIO board (Sam’s code)
Column test with Atlys card(Hard coded version);
Power supply for T3MAPS, development and improvement.
Column test with Atlys card(changeable version);

4. Column test with Atlys card
Expected output: SRCLK_G |||||||||||||||| |||||||||||||||| SRIN_ALL ||||||__|||||| SROUT ||||||__||||||

5. Column test success

6. Power supply Improvement
Phase 1
Phase 2
Phase 3

7. New BNC Oscilloscope Probe Connectors

8. Bo’s New code test No SRclock generated
only column selection generated

9. Difference between Bo’s code and joe’s code
Compare Joe and Bo’s code
Both Joe and Bo’s code 144 bit of dac value.
Joe has 32 bit for config value.
Bo has 29 bit for config value

10. Potential Error Part

11. HOW WE FIXED IT FOR NOW

12. Next step
T3MAPS test for fixed code (we can not test with T3Maps, when professor is not around) if that difference I found is the key point for why Bo’s code doesn’t work We can use the those parameters(is_hit_or, etc) to develop a new code for it. Then we can test and develop the analog test part’s code(because analog test need to use those parameter with potential error).

13. Thank you !