1. 100% REAL EXAM QUESTIONS ANSWERS
CCIE Data Center Written exam in just 24 HOURS!
100% REAL EXAM QUESTIONS ANSWERS
Cisco Interconnecting Cisco Networking Devices Part 1 (ICND)
Buy Complete Questions Answers File from
100% Exam Passing Guarantee & Money Back
Assurance
Sample Questions

2. Answer: A, B, E Question No 4:
In a configuration with redundant supervisors, how many IP addresses are required to configure full remote access via management 0?
Two IP addresses, one for each supervisor
Three IP addresses, one virtual IP and one physical IP for each supervisor
One IP address that is shared among supervisors
None--management 0 will use the IP address from the first SVI that is created
Answer: C Question No 2:
What is required for proper implementation of jumbo frame support on a Cisco Nexus Series Fabric Extender?
The interface configured as FEX fabric requires the MTU to be set to jumbo.
The service policy must be applied to the system QoS.
The device defaults to jumbo frame support; no changes are required.
The switchport in the FEX interface must be set to MTU 9216.
Answer: B Question No 3:
DCNM device discovery is done by connecting to Cisco NX-OS devices and doing which three of these? (Choose three.)
Collecting the running configuration
Raising the logging level to meet the minimum requirement
Discovering all devices by default
Discovering devices using multiple user accounts as long as they are administrator-level accounts
Using LLDP to discover network adaptors
Answer: A, B, E Question No 4:
What does the mac packet-classify command do when applied to an interface configuration?
It enables MAC ACLs to be applied to only IP packets that enter the interface.
It enables MAC ACLs to be applied to only non-IP packets that enter the interface.
It enables MAC ACLs to be applied to all packets that enter the interface.
It enables MAC ACLs to be used for QoS settings.

3. Answer: C Question No 5: Answer: C Question No 6:
In a virtual port channel (vPC) configuration, VRRP exhibits which characteristic?
VRRP does not work with vPC due to industry standard requirements
VRRP works with vPC in traditional active/standby modes
VRRP works with vPC in an active/active mode
VRRP work with vPC as long as vPC peer-gateway is configured to address non-standard replies to the physical MAC address
Answer: C Question No 6:
On Cisco Nexus 5000 Series Switches, where are the virtual output queues implemented, and what is the main purpose of virtual output queues?
On all ingress interfaces; to ensure maximum throughput on a per-egress, per-CoS basis
On all ingress interfaces; to provide independent congestion management and 16 queues
On all egress interfaces; so that a congested egress port does not affect traffic directed to other egress ports
On all egress interfaces; to prevent head-of-line blocking by utilizing multiple virtual output queues
On all egress interfaces; to be able to use EEE 802.1p CoS
Answer: A Question No 7:
On the Cisco Nexus 7000 Series Switch, Control Plane Policing is enforced on which component?
The supervisor module enforces CoPP before out-of-policy traffic reaches the CPU
The fabric modules enforce CoPP in the fabric before out-of-policy traffic reaches the CPU
The linecards enforce CoPP locally before out-of-policy traffic reaches the CPU
The egress virtual output queue enforces CoPP locally before out-of-policy traffic reaches the CPU
Answer: C

4. Question No 8: Answer: D Question No 9: Answer: B Question No 10:
You are troubleshooting a PIM neighbor adjacency that is not coming up. You issued the command show ip pim neighbor e1/18 and confirmed there is no PIM neighbor on the interface. What is the problem based on the debug output?
2012 Feb 23 23:00: pim: [16132] (default-base) Received unauthenticated hello- message from on
Ethernet1/18, message discarded
2012 Feb 23 23:00: pim: [16132] (default-base) Send Hello with AH on
Ethernet1/18 from , holdtimE. 105
secs, dr-priority: 1
The peer router has PIM disabled on its interface connecting to Ethernet1/18.
The peer router has the wrong PIM password configured on its interface connecting to Ethernet1/18.
The local router has the wrong PIM password configured on Ethernet1/18.
The peer router does not have PIM hello authentication enabled on its interface connecting to Ethernet1/18.
The local router does not have PIM hello authentication enabled for Ethernet1/18.
Answer: D Question No 9:
What is the benefit of using Anycast RP via RFC 4610 for IP multicast RP redundancy?
Improves convergence of the multicast network due to enhanced RPF checks
Simplifies the number of control plane protocols over other RP redundancy methods
Eliminates the use of Protocol Independent Multicast (PIM) in the topology
Increases the administrative distances in Multicast Source Discovery Protocol (MSDP) configuration
Answer: B Question No 10:
Which two statements about Cisco Nexus 7000 line cards are true? (Choose two.)
M1, M2, and F1 cards are allowed in the same VDC.
M line cards are service-oriented and likely face the access layer and provide Layer 2 connectivity.

5. PDF Version + Test Engine Software Version
F line cards are performance-oriented and likely connect northbound to the core layer for Layer 3 connectivity.
M line cards support Layer 2, Layer 3, and Layer 4 with large forwarding tables and a rich feature set.
The F2 line card must reside in the admin VDC.
Answer: A, D
Buy Complete Questions Answers File from 100% Exam Passing Guarantee & Money Back Assurance
PDF Version + Test Engine Software Version
90 Days Free Updates Service
Valid for All Countries