1. DAMPE Status (T9) Steadily taking data since last Thursday
Took a couple days to tune the beams and setup the triggers for pion, proton, electron and photon for the DAMPE DAQ and detector conditions
3 DAQ systems synchronized
DAMPE, Spectrometers trackers (AMS ladders), Ancillary detectors (CC, trigger and veto counters, lead-glass electron tagger)
Large amount of good quality data taken
10 GeV pions for alignment and MIP calibration
10 GeV pions angle scan for position resolution studies
Proton energy scan 3.5 to 10 GeV for energy response
Electron energy scan 0.5 – 5 GeV for energy linearity, energy resolution and trigger efficiency
Angle and position scan of 5 GeV electrons
Angle scan of photon produced by 3 GeV electrons
Very grateful to have rather steady beams to T9 in the last week
Hope to have the same until Tuesday next week to complete our program

2. A quite sophisticated photo tag system has been setup by our Bari and Perugia collaborators

4. Brem photons from a 3 GeV electron beam

5. Very preliminary!

6. Very preliminary!

7. Moving to SPS for Nov.
Stop data taking at the evening of the 11th
Disconnect and packing
Move to H4 on Nov. 12th
09h00: Radioprotection inspection
10h00: Transport truck arrival at Bld. 157
10h30: Truck loading complete
11h00: Truck arrival at EHN1
11h30: DAMPE in H4
16h00: Safety and electrical inspection
Help of the technical teams in both experimental areas will be greatly appreciated

8. Preparation of the SPS Setup
Preparation underway, thanks to Adrian and Michael

9. A few details … Remove some items in the area
Beam pipes both upstream and downstream of Goliath
Table inside the Goliath
plate on top of the XY table
Cable rail and support at the back of the area
It would be great if they can be removed before the arrival of the truck (~11h00) next Wed. morning
Set up the magnet
Setup Cerenkov counters
Patrol training
Beam tuning
Proton time