1. Rear Cover Assembly

2. Rear Cover Assembly
The Toodle comes with the rear cover assembled. Normally, there is no need to open the rear cover. In case the rear bearing is stuck inside the Toodle housing during Tool Assembly removal, it is essential to disassemble the rear cover in order to properly remove it. Also, after long storage of the Toodle, it is recommended to remove the rear cover, inspect the O-Ring and clean all Toodle parts before further use.

3. Remove the tool holder from the machine, and place the tool holder with Toodle in the tool holder clamping device.

4. Remove the Toodle from the tool holder.
2. Remove Toodle
1. Release screw - CCW

5. Screw the rear cover CCW using a suitable tool (as snap rings pliers), and remove from housing.

6. Lightly knock the rear bearing out of the housing using a screw driver if needed.

7. Examine the rear cover O-Ring seal. Change the O-Ring as necessary.

8. Thoroughly clean all Toodle parts and remove any corrosion marks.

9. Place the rear cover back into the Toodle housing.

10. Screw the rear cover CW using a suitable tool (as snap rings pliers).
Manual torque 5 to 10 Nm is sufficient.
Torque=5 to 10 [Nm]
Holes diameter = 2 [mm] CW

11. Note the rear cover position as compared to the housing.

12. Place the Toodle into the tool holder.

13. Tighten tool holder after placing Toodle in place
Tighten tool holder after placing Toodle in place. Note: the Toodle front cover surface should touch the tool holder surface.
Tighten screw - CCW