1. MORTER-PRIMER
(Bituminous Primer)

2. USE PACKING CAUTION DESCRIPTION PROPERTIES APPLICATION
MORTER-PRIMER for waterproofing and
moisture-proofing is a liquid bitumen with a proper viscosity that can be applied on the surface of concrete, cement mortar, steel pipe and etc. It is produced by compounding bitumen with rapid-volatile solvent. Therefore, it is used for under-laying liquid and makes adhesive strong to waterproofing layer by forming
membrane on the ground.
Test Item
SPEC.
Test Method
Flash Point(Tag close cup, ℃)
≥42
ASTM D 56
Specific Gravity
≥0.930
ASTM D 70
VOC (Volatile Organic Compounds, g/L)
Below 350 -
Saybolt Furol Viscosity(25℃, sec)
160±10
ASTM D 88
Distillation
Up to 225℃
≥25
ASTM D 402
(Volume % of the primer)
Up to 360℃
Below 40
Test of residue from Distillation
Penetration
(25℃, 100g, 5sec)
ASTM D 5
(up to 360℃)
Solubility of
Trichloroethylene
≥99.0
ASTM D 2042
USE
MORTER-PRIMER is suitable for concrete, smooth asphalt roofs and metal surfaces, and used as the prime coat prior to installation of any MORTER-PLAS membrane
Under layer coating in waterproof and
moisture-proof construction
Under layer coating for anti-corrosion of metal
and protective layer
Preservation of timber against decay
PACKING
20 Liter / Pail
200 Liter / Drum
CAUTION
Put it away from fire when keeping or handling it because it is inflammable
Work in a ventilated place because the gas comes out when you apply it
Keep it sealed perfectly because it evaporates if it is exposed to air for a long time
When the work finished, keep the tools after washing with solvent
APPLICATION
Dry surface up thoroughly
Remove impurities completely such as projecting part, residual, oil scale, rust and etc
Coat it with primer using roller or spray after surface treatment
Coating amount is changeable according to ground level. Refer to below :
Concrete
Tough Mortar
Sliding Mortar
Metal
Timber
Usage (ℓ/㎡)
≥0.4
≥0.2
≥0.1
≥0.3
Applied primer should be dried until its stickiness worn away. Re-apply with primer if 24 hours passed after first coating and there are dusts or sands on its surface

3. Contact information
KOREA
ADD: HANSUK B/D, 166 ICHON-RO, YONGSAN-GSU, SEOUL, KOREA
TEL: FAX:
VIETNAM
ADD: Lafayette, 2nd FL, 8 Phung Khac Khoan, District 1, Hochiminh City, Vietnam
TEL: FAX:
MALAYSIA
ADD: 14th Floor, Kenanga International,
Jalan Sultan Ismail, 50250, Kuala Lumpur, Malaysia.
TEL: FAX: