1. 4 장 신호(Signals) 4.1 아날로그와 디지털(Analog and Digital)
4.2 비주기와 주기 신호(Aperiodic and periodic)
4.3 아날로그 신호(Analog signal)
4.4 디지털 신호(Digital signal)
4.5 요약

2. 신호(cont’d)
Information can be voice, image, numeric data, characters, code, picture, and so on
To be transmitted, information must be into electromagnetic signals.

3. 신호(cont’d)
Transformation of Information to Signals

4. 4.1 Analog and Digital Analog information: continuous(연속: 무게, 키)
Digital information: discrete(불연속, 이산: 학생수)
Analog and digital clocks

5. Analog and Digital(cont’d)
Analog signals can have any value in a range.
Digital signals can have only a limited number of values.
Comparison of analog and digital signals

6. 4.2 Aperiodic and periodic signals
~ consists of a continuously repeated pattern.
The periodic of a signal(T) is expressed in seconds.

7. Aperiodic and periodic signals(cont’d)
Example of periodic signals

8. Aperiodic and periodic signals(cont’d)
Aperiodic signals(비주기 신호)
~ changes constantly without exhibiting a pattern or cycle that repeat over time.

9. Aperiodic and periodic signals(cont’d)
Example of aperiodic signals

10. 4.3 Analog signals ~ can be classified as simple or complex.
Simple Analog signals
the sine wave is the most fundamental form of a periodic analog signal.

11. Analog signals(cont’d)
A sine wave

12. Analog signals(cont’d)
Sine wave can be fully described by three characteristics
amplitude(진폭)
period(주기), frequency(주파수)
phase(위상)

13. Analog signals(cont’d)
Amplitude(진폭)
~ refer to the height of the signal.
특정 순간의 신호 값; voltage(전압), amperes(전류), watts(전력)
Period(주기), Frequency(주파수)
Period
~ refers to the amount of time, in seconds, a signal needs to complete one cycle.
Frequency
~ refers to number of periods a signal makes over the course of one second.(주기의 역수(1/t), 초당 주기의 반복 횟수)

14. Analog signals(cont’d)
Frequency=1/Period, Period=1/Frequency
f = 1 / T , T = 1 / f
Unit of Frequency
~ is expressed in Hertz(Hz).
Unit of Period
~ is expressed in seconds.

15. Analog signals(cont’d)
Units of frequency and period

16. Analog signals(cont’d)
Example 4.1
A sine wave have a frequency of 8KHz. What is its period ?
Solution
Let T be the period and f be the frequency. Then,
T = 1/f = 1/8,000 = = 125 s

17. Analog signals(cont’d)
Example 4.2
A sine wave completes one cycle in 25 s. what is its frequency?
Solution
Let T be the period and f be the frequency. Then,
f = 1/T = 1/(25*10-6) = 40,000 = 40 KHz

18. Analog signals(cont’d)
Phase(위상)
~ describes the position of the waveform relative to time zero(단일 주기내에서 시간에 대한 상대적인 위치).

19. Analog signals(cont’d)
Relationship between different phases

20. Analog signals(cont’d)
Amplitude change(진폭 변조)

21. Analog signals(cont’d)
Frequency change(주파수 변조)

22. Analog signals(cont’d)
Phase change(위상 변조)

23. Analog signals(cont’d)
More about Frequency
Frequency is rate of change with respect to time
Change in a short span of time means high frequency.
Change in a long span of time means low frequency.
Two Extremes
If a signal does not change al all, its frequency is zero.
If a signal changes instantaneously, its frequency is infinity.

24. Analog signals(cont’d)
Time versus Frequency Domain
Time Domain : instantaneous amplitude with respect to time.
Frequency Domain : maximum amplitude with respect to frequency.

25. Analog signals(cont’d)
Time and Frequency domains

26. Analog signals(cont’d)
Time and Frequency domains for different signals

27. Analog signals(cont’d)
Complex Signals
A periodic signal decomposed into two sine waves.
A signal with a DC component
A composite signal decomposed into four components.
Complex waveform

28. Analog signals(cont’d)
A signal with a DC component

29. Analog signals(cont’d)
Complex waveform

30. Analog signals(cont’d)
Frequency Spectrum and Bandwidth
The frequency spectrum of a signal is the combination of all sine wave signals that make signal.
The bandwidth of a signal is the width of the frequency spectrum.

31. Analog signals(cont’d)
Bandwidth

32. Example 4.3
If a period signal is decomposed into five sine waves with frequencies of 100, 300, 500, 700, and 900 Hz, What is the bandwidth?
Solution
Let fh be the highest frequency, fl be the lowest frequency, and B be the bandwidth. Then,
B = fh - fl = = 800 Hz

33. Example 4.4
A signal has a bandwidth of 20 KHz. The highest frequency is 60 KHz. What is the lowest frequency?
Solution
Let. fh : highest frequency
fl : lowest frequency
B : Bandwidth
B = fh - fl  20 = 60 - fl = fl = = 40 KHz

34. 4.4 Digital Signals
A digital signals

35. Digital Signals(cont’d)
Amplitude(진폭), periodic(주기), phase(위상)

36. Digital Signals(cont’d)
Bit Interval and Bit Rate
Bit Interval
~ is the time required to send one single bit.
Bit Rate
~ is the number of bits sent in one second.

37. Digital Signals(cont’d)
Bit rate and bit interval

38. Digital Signals(cont’d)
Decomposition of a Digital Signal
Harmonics(고조파) of a digital signal

39. Digital Signals(cont’d)
Exact and significant spectrums

40. Digital Signals(cont’d)
The bit rate has a relationship to the significant bandwidth such that when the bit rate increases, the significant bandwidth widens.

41. Digital Signals(cont’d)
Bit rates and significant spectrums

42. Digital Signals(cont’d)
Medium Bandwidth and Significant Bandwidth
corruption of a digital signal due to insufficient medium bandwidth

43. Digital Signals(cont’d)
Medium Bandwidth and Data Rate : Channel Capacity
Medium Bandwidth and Data Rate

44. Digital Signals(cont’d)
Use of Analog Signals to Transmit Digital Data
Example 4.5
What bandwidth is required for data being sent at a rate of 10 bps using analog signals? Assume the each signal element is one bit.
Solution

45. Digital Signals(cont’d)
Example 4.6
compare the bandwidths required for analog data being sent at 1,000 and 10,000 bps
Solution
10 bps - 5 Hz
1,000 bps Hz
10,000 bps - 5,000 Hz
As the data rate increases, the bandwidth also increases.

46. Digital Signals(cont’d)
Example 4.7
We want to transmit 10 pictures per second. Each picture is made 5-by-5 pixels. What is the required bandwidth using digital encoding.
Solution
1 page = 25 pixels
25 bit/picture * 10 = 250 bps
125 Hz

47. Digital Signals(cont’d)
Example 4.8
A television screen is composed of a grid of 525 lines by 700 columns(total of 367,500 pixels). A pixel can be black or white(0 or 1). Thirty complete screens(frames) are scanned in one second. What is the theoretical bandwidth required?
Solution
Bandwidth = (30 * 367,500)/2
= 11,025,000/2
= 5,512,500 = 6 MHz(근사값)

48. Digital Signals(cont’d)
Example 4.8

49. 4.5 요약