1. Grout and
Other Reinforcement
Module

2. Upon completion of this module, you will be able to:
Transparency 1
Objectives
Upon completion of this module, you will be able to:
1. Name and describe the primary ingredients in grout and their properties.
2. Identify the different types of grout used in masonry work.
3. Describe the common admixtures and their uses.
4. Describe the use of steel bar reinforcement in masonry construction.
5. Apply grout in low and high lifts using the proper techniques.
6. Place grout in a hollow block wall and rod it into place.

3. 1. Place grout in a hollow block wall and rod in place.
Transparency 2
Performance Task
1. Place grout in a hollow block wall and rod in place.
2. Pour grout for a two-lift pour.

4. Transparency 3
Figure 2 – Slump Test for Concrete, Mortar, and Grout

5. Transparency 4
Table 1 – Grout Mix Formula

6. Transparency 5
Table 2 – Allowable Grout Pour Heights

7. Transparency 6
Figure 4 – Typical Reinforced Concrete
Masonry Construction Using Low-Lift Grouting

8. Transparency 7
Figure 7 – Continuous Cleanout Openings

9. Transparency 8
Figure 10 – Reinforcement Bar Identification

10. Transparency 9
Table 3 – ASTM Standard Metric and Inch-Pound
Reinforcing Bar

11. Transparency 10
Table 4 – Reinforcing Bar Types

12. Transparency 11
Table 5 – Reinforcing Bar Grades

13. Transparency 12
Figure 11 – Rebar Spacers

14. Transparency 13
Figure 12 – Vertical Reinforcement

15. Transparency 14
Figure 13 – Placing Rebar in a Bond Beam

16. Transparency 15
Figure 14 – Bond Beam Shapes