1. From Design to Installation courtesy R. Folch S. Atieh TS / MME
FP420 NCC
From Design to Installation
courtesy
R. Folch S. Atieh TS / MME

2. New Connection Cryostat
16 July 2008
D. FP420 meeting

3. Critical Components shuffling box bottom trays cold feet etc.
busbar and cables
16 July 2008
D. FP420 meeting

4. Design and Manufacturing Issues
Material requirements
Vacuum requirements
Cryogenic calculations
Integration of beam screens
Integration of cold/warm transitions
Electrical specification and calculations
Instrumentation and cabling
Standard required tests
Cold test (if required)
16 July 2008
D. FP420 meeting

5. Important components Beam screens Cold-warm transitions
Vacuum chambers and vacuum systems
Standard LHC components (cold feet, bottom trays, AL-SS transitions, etc.)
Instrumentation devices
16 July 2008
D. FP420 meeting

6. Critical components/delays
Superconducting bus-bar and cables (to be produced)
Shuffling box (problematic if not from LHC)
Supporting beam ~ 3-4 month delay
Vacuum vessel ~ 4 month delay
16 July 2008
D. FP420 meeting

7. Minimal Project Schedule
months 1 2 3 4 5 6 7 8 9 10 11 12
Project Approval
Remaining Design
Engineering review
Production
Assembly
Start Installation
Installation constraint by LHC shutdown periods
Replacement of a connection cryostat requires warm up of complete sector!
16 July 2008
D. FP420 meeting

8. Starting conditions Approval of FP420 & funding
WP approval (EDMS ) *
Pre-design approval
Pressure equipment ⇒ AWP’s and welder qualifications
Assembly in bldg. 112 is desirable & possible
Transport and alignment (available in TS department)
* detailed cost evaluation required; i.e. Bus-bars, instrumentation, tooling, ...
16 July 2008
D. FP420 meeting

9. 16 July 2008
D. FP420 meeting

10. 16 July 2008
D. FP420 meeting