1. Cedar 1-2 (row 1-2) P/T values given in mol/m^3
for the HEAD(red)/MIDDLE(green)/TAIL(blue) temperature probes.
The first column shows the correlation between the temperature of the precision pressure probe (°C, x-axis) and the gas pressure (bar, y-axis)

2. Zooms: density variation of gas are shown
Cedar 1-2 (row 1-2) P/T
Zooms: density variation of gas are shown
They shows both increasing and decreasing trends and are not always related to pressure scans
The relative variation in density is
~2.5 10^-3
While CEDAR reuirements by desing are
~10^-4

3. Cedar 1-2 (row 1-2) Insulation Factors
Obtained for the HEAD/MIDDLE/TAIL temperature probes.
The values are the ratios between the maximum temperature difference inside the vessel and outside the temperature shielding for different time windows (on x-axis, hours)
The shielding factor seem to be factor 3-5
while the design requirement reports a factor 20-80

4. Cedar 1-2 (row 1-2) Majorities Ratios
8/6 (red), 8/7 (green) and 7/6 (blue)
Obtained by asking time differences between majorities 8,7 and 6 less than 1 second
Thus they should be related to the same spill.