1. Fabtech Technical Campus Poly. (Shift), Sangola.
Presentation on
AUTOMOBILE ENGINEERING
Chapter no.03
Control System
By:
Mr.Solage R.D.
(Lecturer in Mech. Engg.Dept.)

2. Chapter no.03 Control System
King pin

4. Steering Gear box 1.Rack and Pinion steering Gear
2.Recirculating Ball Steering system

5. 1.Rack and Pinion steering Gear

6. 2.Recirculating Ball Steering system

7. STEERING GEOMETRY
Wheel Geometry
The term "steering geometry" (also known as "front-end geometry") refers to the angular Relationship between suspension and steering parts, front wheels, and the road surface. Because alignment deals with angles and affects steering, the method of describing alignment measurements is called steering geometry.
There are five steering geometry angles : Camber , Caster ,Toe, Steering axis inclination, and Toe-out on turns

9. Camber-:The camber is the tilt of the front wheel from the vertical plane

10. Camber is the angle of the wheel, measured in degrees, if the top of the wheel is tilted out then the camber is positive, if it's tilted in, then the camber is negative.

12. King Pin Inclination(KPI)

13. King pin inclination The king pin inclination is the inward tilt of the king pin from the vertical plane.

14. Caster-:

16. Toe-In and Toe-Out

17. TOE IN and TOE OUT

18. Power Steering-:

20. Braking System-: Types of braking System 1.Mechanical Braking System
i) Drum Type brake
ii) Disc type brake
2.Hydraulic Braking System
3.Air Braking System

21. i) Drum Type brake

22. ii) Disc type brake

24. 2.Hydraulic Braking System

25. Master Cylinder

26. 3.Air Braking System(Pneumatic System)

29. THANK YOU