1. AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra
Remove seat from vehicle
Remove rocker panel covers (both front and rear)
Remove B-pillar cover and re-attach seatbelt anchor to B-pillar, remove door panel 4
Tuck OEM wire harness in and pull through carpet by heat duct as shown
AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra

2. AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra5 5
Remove seat risers by drilling out rivets and spot welds. Use ¼” drill.
AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra

3. AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra
Seat tracks should look like this after drilling 7
AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra

4. 8 9 AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra
Place ER into vehicle as shown
Modify and reinstall B-pillar cover accordingly 9
Tuck OEM wire harness under ER as shown to come out at rear of ER
AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra

5. AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra10
Manually rotate ER out to install OEM seat onto ER seat base
11. Use ¼-20 x ½ button head bolts to bolt seat onto ER. (Two each side at rear of tracks, one each side at front of tracks.)
AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra

6. AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra12
Slide seat all the way back. Manually rotate seat into vehicle as shown. 13
If required cut door panel here and finish
AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra

7. AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra
14. Attach OEM wire harness under seat using cable ties and connect plugs to seat position sensor and seatbelt latch. Be sure that wires do not interfere with the seat sliding forward and backward, nor with the operation of the Easy-Reach.
AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra