1. Date of download: 12/26/2017
Copyright © ASME. All rights reserved.
From: Introduction of a New Numerical Simulation Tool to Analyze Micro Gas Turbine Cycle Dynamics
J. Eng. Gas Turbines Power. 2016;139(4): doi: /
Figure Legend:
Illustration of gas phase module interconnection of three adiabatic pipes via two plena (arrow indicates flow direction; variables in nomenclature)

2. Date of download: 12/26/2017
Copyright © ASME. All rights reserved.
From: Introduction of a New Numerical Simulation Tool to Analyze Micro Gas Turbine Cycle Dynamics
J. Eng. Gas Turbines Power. 2016;139(4): doi: /
Figure Legend:
Recuperator module—heat flow calculation scheme

3. Date of download: 12/26/2017
Copyright © ASME. All rights reserved.
From: Introduction of a New Numerical Simulation Tool to Analyze Micro Gas Turbine Cycle Dynamics
J. Eng. Gas Turbines Power. 2016;139(4): doi: /
Figure Legend:
Scheme of the T100 MGT model (BC = boundary condition, P = plenum, CC = combustion chamber, T = turbine, C = compressor, TM = thermal mass, FC = free convection, and PI/PID = controller)

4. Date of download: 12/26/2017
Copyright © ASME. All rights reserved.
From: Introduction of a New Numerical Simulation Tool to Analyze Micro Gas Turbine Cycle Dynamics
J. Eng. Gas Turbines Power. 2016;139(4): doi: /
Figure Legend:
Steady-state validation results of air and fuel mass flows at various operation points

5. Date of download: 12/26/2017
Copyright © ASME. All rights reserved.
From: Introduction of a New Numerical Simulation Tool to Analyze Micro Gas Turbine Cycle Dynamics
J. Eng. Gas Turbines Power. 2016;139(4): doi: /
Figure Legend:
Steady-state validation results of electrical power output and electrical efficiency at various operation points

6. Date of download: 12/26/2017
Copyright © ASME. All rights reserved.
From: Introduction of a New Numerical Simulation Tool to Analyze Micro Gas Turbine Cycle Dynamics
J. Eng. Gas Turbines Power. 2016;139(4): doi: /
Figure Legend:
Recuperator exhaust outlet temperature from measurement dataset 1 and simulation results with full and with low casing heat capacities; shaft speed increased from 80% to 100% in 5% steps (upper part) and magnified detail (lower part)

7. Date of download: 12/26/2017
Copyright © ASME. All rights reserved.
From: Introduction of a New Numerical Simulation Tool to Analyze Micro Gas Turbine Cycle Dynamics
J. Eng. Gas Turbines Power. 2016;139(4): doi: /
Figure Legend:
Measurement data of cold start procedure and simulation results with full and with low casing heat capacities; recuperator air outlet temperature (upper part) and fuel mass flow (lower part)

8. Date of download: 12/26/2017
Copyright © ASME. All rights reserved.
From: Introduction of a New Numerical Simulation Tool to Analyze Micro Gas Turbine Cycle Dynamics
J. Eng. Gas Turbines Power. 2016;139(4): doi: /
Figure Legend:
Measurement data of shutdown procedure and simulation results with full and with low casing heat capacities; recuperator air outlet temperature (upper part) and electrical output power (lower part)