Download presentation
Presentation is loading. Please wait.
1
Flip-Flops SHAH KEVAL EN. NO.: 130270111006 EC DEPARTMENT,
KIT, JAMNAGAR.
2
Level-Sensitive Flip-Flop
Level-sensitive flip-flop (also called a “latch”) “Q” changes whenever clock is “high” CLK D Q 6 Transistors CLK CLK D Q
3
Level-Sensitive Flip-Flop
CLK D Q NMOS transistor often replaced with “transmission gate” “Transmission gate” includes both NMOS and PMOS transistors because NMOS good at passing “0” and PMOS good at passing “1” 6 Transistors CLK D Q CLK Transmission Gate 8 Transistors CLK
4
Master-Slave Edge-Triggered Flip-Flop
Can connect two level-sensitive latches in Master-Slave configuration to form edge-triggered flip-flop Master latch “catches” value of “D” at “QM” when CLK is low Slave latch causes “Q” to change only at rising edge of CLK QM Master Latch Slave Latch D Q CLK 2 x 8 = 16 Transistors CLK CLK D QM Q
5
Master-Slave Edge-Triggered Flip-Flop
QM D Q CLK CLK 2 x 8 = 16 Transistors
6
More Efficient Master-Slave Edge-Triggered Flip-Flop
Called a C2MOS (Clocked CMOS) design MASTER SLAVE VDD VDD CLK CLK D Q CLK CLK 8 Transistors GND GND
7
Using Logic Gates to Build Flip-Flops
From previous slides, you can see that it’s possible to build an edge-triggered flip-flop using just 8 transistors In a conventional “Digital Logic” course, transistor-level flip-flop designs are not usually taught Instead, flip-flop designs using “cross-coupled” logic gates are usually taught
8
RS-Latch as Cross-Coupled NOR Gates
If R = 1, Q resets to 0 If S = 1, Q sets to 1 If RS = 00, no change RS = 11 is not allowed because leads to oscillation R Q Q S S R Q 0 0 No change 0 1 1 0 1 1 1 Undefined
9
Level-Sensitive RS-Latch
“Q” only changes when CLK is high (i.e. level-sensitive) When CLK is high, behavior same as RS latch S Q CLK Q R CLK S R Q X X No change No change 1 Undefined
10
Level-Sensitive D-Latch
Make level-sensitive D-latch from level-sensitive RS-latch by connecting S = D and R = not D Compared to transistor version D Q CLK Q 18 Transistors CLK D Q 8 Transistors
11
Master-Slave Edge-Triggered Flip-Flop
Master-Slave configuration Compared to transistor version MASTER SLAVE D Q CLK CLK 36 Transistors VDD VDD CLK CLK D Q CLK CLK 8 Transistors GND GND
12
Alternative Edge-Triggered Flip-Flop
VDD VDD CLK CLK Q D Q CLK CLK CLK Q GND GND D 24 Transistors 8 Transistors
13
JK Flip-Flop from D-Latch
Same as RS-Latch except “toggle” on 11 J D Latch Q K Q CLK JK-FF J Q CLK J K Q X X No change CLK No change K 1 Toggle
14
Toggle Flip-Flop from D-Latch
Toggles stored value if T = 1 when CLK is high D Latch Q T CLK CLK T Q T T-FF Q X No change No change CLK Toggle
Similar presentations
© 2024 SlidePlayer.com. Inc.
All rights reserved.