1. Testbed 7) Wheel Assembly 6) Battery Strap 8) Clawbot 5) Limit Switch
Build the testbed in this order.
If you prefer to collect your parts
before you start to build there is
a video on Canvas to assist with
this (optional).
Cortex
Potentiometer. Attach with 2 screws/nuts (hidden in picture)
Bumper Switch
Line Tracking Sensor
Limit Switch
Battery Strap (don’t insert Battery yet)
Wheel Assembly. 4 videos
on Canvas to assist. Use the
gold screws as the skinny
screws in this step. Notice from
the picture that only 2 black
plastic bearings are needed, not
the 3 shown in the video.
Clawbot. See pic on back for proper placement.
Connect wires to Cortex. See back of this page for assistance. The 2 wheel motors need to have a Motor Controller cord attached to them before attaching to the Cortex. Notice the Green LED- insert this, as well.
Testbed
7) Wheel Assembly
6) Battery Strap
8) Clawbot
5) Limit Switch
Cortex
2) Potentiometer
3) Bumper Switch
4) Line Follower

2. Testbed Wiring Guide
Clawbot attached. Your claw may be parallel to the ground (not at an angle like this one).