1. Parul Polytechnic Institute
Subject Code :
Name Of Subject : Microprocessor and assembly language programming
Name of Unit : Introduction to microprocessor
Topic : Multiplexed address and data bus
Name of Faculty : H.M.Avaiya & N.D.Dhameliya
Name of Students: (i) Parekh Krishna(038)
(ii) Shah Rutu(054)

2. MICROPROCESSOR ARCHITECTUR AND MICROPROCESSOR SYSTEM

3. DEMULTIPLEXING MULTIPLEXED ADDRESS/DATA BUS

4. The multiplexed address/data bus Ad7-AD0 is used to transfer data and address both.
In order to perform the read or write operation , the memory device requires to identify memory location which is specified by 16-bit address.
The higher-order address is available through A15-A8 address lines and lower-order address is available through AD7-AD0.

5. [ FIG : DE MULTIPLEXING OF MULTIPLEX ED ADDRESS DATA BUS.]

6. The lower-order address must be latched as it is required by the memory device and AD7-AD0lines must be made free to transfer data.
The ALE signal is used to demultiplex AD7-AD0 as shown in figure.
During initial period of instruction execution ALE goes high and multiplexed address/data bus AD7-AD0contains lower byte of the 16-bit address.

7. When ALE goes low, this lower – order address is latched into latch and is made available to the memory device.
It makes the multiplexed path free for data transfer.

8. THANKYOU