1. Preparing to Use a Table Saw

2. Safety Notice - Brand Disclaimer
The viewer is expressly advised to consider and use all safety precautions described in this presentation or that might also be indicated by undertaking the activities described herein. In addition, common sense should be exercised to help avoid all potential hazards.
Publisher assumes no responsibility for the activities of the viewer or for the subject matter experts who prepared this presentation. Publisher makes no representation or warranties of any kind, including but not limited to, the warranties of fitness for particular purpose or merchantability, nor for any implied warranties related thereto, or otherwise. Publisher will not be liable for damages of any type, including any consequential, special or exemplary damages resulting, in whole or in part, from viewer's use or reliance upon the information, instructions, warnings or other matter contained in this presentation.
Brand Disclaimer
Publisher does not necessarily recommend or endorse any particular company or brand name product that may be discussed or pictured in this presentation. Brand name products are used because they are readily available, likely to be known to the reader, and their use may aid in the understanding of the presentation. Publisher recognizes that other brand name or generic products may be substituted and work as well or better than those featured in the presentation.

3. Preparing to Use a Table Saw
Always wear eye protection.

4. Preparing to Use a Table Saw
When setting up the saw, check to see that
The blade is securely fastened to the arbor.
The saw blade revolves freely in the correct direction.
Any clamps or knobs on the fences are properly tightened.
In this photo, a wrench is being used to fasten the blade.

5. Preparing to Use a Table Saw
Have your instructor check all special setups and blade changes before the saw is started.

6. Preparing to Use a Table Saw
When changing saw blades or using a dado head, make sure the main switch is off.
When possible, pull the plug from the receptacle to prevent accidental starting.

7. Preparing to Use a Table Saw
Raise the saw blade from ⅛ to ¼ inch higher than the thickness of the stock to be cut.

8. Preparing to Use a Table Saw
Make sure that the antikickback pawls (fingers) behind the saw blade are always in place.
Antikickback Pawl
(In Red for Visibility)

9. Preparing to Use a Table Saw
These resist the tendency of the saw to throw the stock backward and toward the operator.
Antikickback Pawl
(In Red for Visibility)

10. Preparing to Use a Table Saw
Always use the saw guard. Never operate the saw without the guard in place unless a special jig or fixture is used as a guard.

11. Preparing to Use a Table Saw
Credits
Safety Glasses courtesy of
Aearo Corporation
All other photography by
Kevin May Corporation
Technical Assistance by
Larry Kruzan