1. CONNECTION METHOD (X-Band Microwave Motion Sensor Modules)
<Reference>
1) If you check IF output,
① if you check voltage with tester (DVM), V~ +0.02V (X10) is appeared.
② The signal is analog signal. In case you check with oscilloscope (100MHz),
analog wave is appeared. 2) As mentioned above, IF shows output signal and
voltage V~ +0.02V (X10) independently.
2) The check points are 2 points, "GND" and "IF" utilizing voltage tester (DVM).
3) Be sure to connect correctly (+,-) to power supply. The reverse connection of
"+" and "-" will damage module.
4) Be sure to supply power to module between 4.7VDCand 5.3VDC.
CONNECTION METHOD (X-Band Microwave Motion Sensor Modules)
Model No. : DNS-000 Series
OUTPUT – (1)Voltage: VCC ~ +0.02VCC(X10)
– (2)Signal : Analog Signal
Dnet Co.,Ltd.
Tel) , Fax)
Web-site:

2. Outline Drawing (X-Band Microwave Motion Sensor Modules)
Model No.:DNS-000 Series
(Applications)
1. traffic / express highway watch and
control.
2. security relation products (sensor and
alarm set etc).
3. automobile rear collision warning.
4. automatic door activation.
5. sensor light.
6. sensors it applies in all products which
operate.
GND
GND
+5V IF
Dnet Co.,Ltd.
Tel) , Fax)
Web-site: