1. VERIFY JUMPER POSITIONS AS SHOWN BELOW
MONGOOSE MAP1100S ALARM UPGRADE – TOYOTA COROLLA 2003 VVTL
A B C D E F
A PLUG-IN PROGRAMMING SWITCH
B PLUG-IN LED
C PLUG-IN DISABLE WIRES
D 6 pin MODULE CONTROL PLUG
E 12 pin ALARM PLUG
F PLUG SHOCK SENSOR
CLOSED
OPEN
VERIFY JUMPER POSITIONS AS SHOWN BELOW
S S1 1 2 3 4 5
12 PIN PLUG – ALARM INPUTS/OUTPUTS
LABEL CONNECTION
(-) Ground Chassis
(-) Ground Chassis
(+) Output to siren Output to Siren Loom
(-) Door Trigger Red/White at Ignition switch (light)
(-) Armed Ground Output Not Used
(+) Door trigger Not Used
7-----FUSED---- (+) Constant 12v Black at Ignition switch
(-) Bonnet Run own wire
9-----FUSED---- (+) Light flash output Green at light switch
(-) Boot Factory Connected to Doors
11---FUSED---- (+) Light flasth output Green at light switch
(+) Ignition input Black/White at Ignition switch
6PIN PLUG – ALARM ARM / DISARM
INPUTS
(-) Light flash/ Disarm input Yellow/Green at indicator relay behind pocket D/S
(+) Disarm input Solenoid wire kick trim red drivers door loom
Alternate/Boot Bypass Not Used
(+) Arm input Solenoid wire kick trim blue drivers door loom
OUTPUTS
Unlock - OP Blue/Red at plug righthand kick trim
Lock - OP Green/Yellow at plug Righthand kick trim
DO NOT
REMOVE
Move
Program #3 on
Default Factory Settings
"Whilst every effort has been made to ensure the accuracy of the information contained in these files, due to constant changes in vehicle manufacturing and sourcing of components, wiring colours and locations may vary. Always verify supplied information with a multi-meter before making connections. Mongoose accepts no responsibility or liability for any incorrect information or damage due to wrong connection.
DATE: 07/10/03
NL/SD