1. IBL activities ATLAS Meeting Milano, 14 May 2012 S. Coelli,
Servizio Progettazione e Officina Meccanica – INFN MILANO
A. Capsoni, M. Monti, F. Tomasi, E. Viscione

2. IBL project EDMS reports
FEM SIMULATION REPORTS FOR THE IBL STAVE
Number: ATU-SYS-EA-0007  v.1
THE SUB-DOCUMENTS ATTACHED TO THIS ONE INCLUDE THE REPORT USED FOR THE IBL TDR.
THERMAL FIGURE OF MERIT USING A FACEPLATE
STAVE DEFORMATIONS UNDER THERMAL AND GRAVITATIONAL LOADS, SEVERAL BOUNDARY CONDITIONS. DYNAMIC ANALYSIS
WORK IN PROGRESS => EXPERIMENTAL MEASUREMENT OF THE STAVE DEFORMATION INDUCED BY THE COOLING
IBL STAVE FEM SIMULATIONS REPORTS FOR THE TDR
01 - MECHANICAL SIMULATIONS VALIDATION REPORT
02 - STEADY-STATE THERMAL ANALYSIS OF THE STAVE
03 - STRUCTURAL ANALYSIS OF THE COOLING CARBON PIPE
04 - THERMO-MECHANICAL ANALYSIS OF THE STAVE
05 - STAVE_THERMAL_FIGURE_OF_MERIT
06 - CF-Ti JOINT OVERBRAID OPTIMIZATION
07 - REFINED STAVE THERMAL FIGURE OF MERIT
08 - STAVE DYNAMIC ANALYSIS

3. RECENTLY MEASURED THERMAL PERFORMANCE OF THE IBL STAVE PROTOTYPE CONFIRMS THE DESIGN ANALYSIS

5. EXTRACT AS EXAMPLE ..EFFECTS OF DIFFERENT FLEXBUS DESIGN
..EFFECTS OF DIFFERENT FACEPLATE DESIGN

6. EXPERIMENTAL MEASUREMENT OF THE STAVE DEFORMATION INDUCED BY THE COOLING
TEST OF INFRARED TRANSPARENT MATERIALS FOR THERMAL IMAGE
TAKEN USING A I.R. CAMERA (FLIR)
TEST BOX INSTALLED IN THE LASA METROLOGY LAB.
COOLED USING NITROGEN SPILLED FROM A LN2 RANGER
OPTICAL MEASUREMENT OF THE STAVE DISPLACEMENT IN SEVERAL POINTS
CONSTRAINS ATTACHED TO INVAR REFERENCE BAR
TEMPERATURE THERMORESISTANCE PT100 SENSORS

7. ATLAS PIXEL DETECTOR INTEGRATION AND TESTING TOOL (ITT)
SET-UP OF THE TOOL INTO THE CERN CLEAN ROOM (SR-1)
ASSEMBLING STARTED IN MARCH 2012
THE SCOPE (TO BE DECIDED)
TO MAKE POSSIBLE THE INTEGRATION OF:
- NEW SERVICE QUARTER PANELS (nSQP)
- NEW BEAM-PIPE
- WITH INTEGRATED IBL

8. ATLAS PIXEL DETECTOR INTEGRATION AND TESTING TOOL (ITT) MARCH 2012 SET-UP INTO CERN CLEAN ROOM SR-1

9. ATLAS PIXEL DETECTOR INTEGRATION and INSTALLATION
2006
2006