1. STATUS OF THE DAQ+MOVEMENT CARIPARO PROGRAM
Hao Xin

2. OVERVIEW TASK OF THE PROGRAM:
USER INTERFACE FOR DAQ, MOVEMENTS AND CHECKS
SOFTWARE:
WINDOWS OPERATING SYSTEM
LABVIEW 8
DAQ: EURITRACK SOFTWARE BASED
MOVEMENTS: LABVIEW
THE PROGRAM HAS BEEN DEVELOPED TO WORK IN 2 MODES:
FULLY AUTOMATIZED
USER CONTROLLED

3. THE SOFTWARE IDEA STARTING POINT: MEASUREMENT DEFINITION:
MOTORS MOVEMENTS + DAQ
CONFIGUARATION (.TXT) FILE WITH INFORMATION ABOUT:
COMMENTS
DIFFERENT SETS OF MEASUREMENTS
MOTORS SETUP
....(AND MORE, IF NECESSARY, I.E. DAQ SETTINGS)

4. Example of Configuration File:

5. FLOW CHART

6. FRONT PANEL OF THE PROGRAM

7. SOME DETAILS
To open a configuration file, the default is to open configuration.txt file.
To open a log file, the default is to open logfile.txt file and it is a write-only file.
There is a file dialog for the user edition. The user should press OK when the movement of each motor is completed and DAQ is finished and another OK after each measurement is finished.

8. ANY SUGGESTION IS WELLCOME!