1. SAE Formula Status Report
Gabrielle Godette Joseph Whiteman Chelsea Newnam
Forrest Copeland Cushmeer Sargent Carmen MonteCalvo
Donald Engler Mason Rusch Matthew Calvert
John Anderson Aaron Baker
Speakers will be Carmen, Cushmeer, Jake, Chelsea, and Mason

2. Introduction
The main goal for this semester is to provide the formula sae club with a functional aerodynamic package.
The four main parts: Front wing, Nose cone, Diffuser, Side Pods, and Rear wing.
Designs are being closed to finalized and are ready to be 3D printed
After 3D printing, small scale testing will be utilized to compare our CFD results with results from the wind tunnel testing.
Touch up our designs based on the results the team got from wind tunnel testing.

3. Front Wing
Optimized based on research of scholarly articles and books, listed later in sources slide
Completed full design analysis utilizing Xflyr and Solidworks with a wide range of Reynolds Numbers
Each design aspect has a technical justification
Specifications:
Airfoil: Eppler 420
Main Element: Chord: 17in AOA: 7 Degrees
Flap Element: Chord: 8in AOA: 30 Degrees
Gap: in
Overlap: 1.3in
Width: 57in (outside to outside tires)
Endplates: As large as possible while conforming to rules

4. Nose Cone
Designed primarily to cover the front portion of the frame with the impact attenuator attached
Solidworks CFD shows a decrease in average drag and lift from the old design to the current one at 30 mph
Location of the front tires and/or frame changes could affect the design of the nose

5. Undertray/Diffuser
Made some minor adjustments from the last iteration and downforce has increased
Design creates low pressure vortices at the exit
Design should not obstruct the engine, wheels, or frame

6. Rear Wing Two Eppler 420 airfoils Chord length 14 and 5
One Eppler 420 airfoil
Chord length 20
One Eppler 423 airfoil
Chord length 20

7. Rear Wing
Eppler 420
Eppler 423

8. Side Pods
No longer need to be made since radiator size is still not finalized by the club.
Instead the design and creation of the side pods will be up to the cooling and oiling team from the Formula Club.
The sidepod sub group will now be repurposed to the aid in the testing and fabrication of our scale model design.

9. Gantt Chart Discuss actions from now until the final showcase
Wait for chelsea to upload the new gantt chart before posting to website.

10. Questions?