1. Transport in Plants

2. Why does over-watering kill a plant?
Transport in plants
H2O & minerals
transport in xylem
transpiration
evaporation, adhesion & cohesion
negative pressure
Sugars
transport in phloem
bulk flow
Calvin cycle in leaves loads sucrose into phloem
positive pressure
Gas exchange
photosynthesis
CO2 in; O2 out
stomates
respiration
O2 in; CO2 out
roots exchange gases within air spaces in soil
Why does over-watering kill a plant?

3. Ascent of xylem fluid
Transpiration pull generated by leaf

4. Water & mineral absorption
Water absorption from soil
osmosis
aquaporins
Mineral absorption
active transport
proton pumps
active transport of H+
aquaporin
root hair
proton pumps
H2O

5. Mineral absorption Proton pumps
active transport of H+ ions out of cell
chemiosmosis
H+ gradient
creates membrane potential
difference in charge
drives cation uptake
creates gradient
cotransport of other solutes against their gradient
The most important active transport protein in the plasma membranes of plant cells is the proton pump , which uses energy from ATP to pump hydrogen ions (H+) out of the cell. This results in a proton gradient with a higher H+ concentration outside the cell than inside. Proton pumps provide energy for solute transport. By pumping H+ out of the cell, proton pumps produce an H+ gradient and a charge separation called a membrane potential. These two forms of potential energy can be used to drive the transport of solutes.
Plant cells use energy stored in the proton gradient and membrane potential to drive the transport of many different solutes. For example, the membrane potential generated by proton pumps contributes to the uptake of K+ by root cells.
In the mechanism called cotransport, a transport protein couples the downhill passage of one solute (H+) to the uphill passage of another (ex. NO3−). The “coattail” effect of cotransport is also responsible for the uptake of the sugar sucrose by plant cells. A membrane protein cotransports sucrose with the H+ that is moving down its gradient through the protein.
The role of proton pumps in transport is an application of chemiosmosis.

6. Water flow through root
Porous cell wall
water can flow through cell wall route & not enter cells
plant needs to force water into cells
Casparian strip
The endodermis, with its Casparian strip, ensures that no minerals can reach the vascular tissue of the root without crossing a selectively permeable plasma membrane. If minerals do not enter the symplast of cells in the epidermis or cortex, they must enter endodermal cells or be excluded from the vascular tissue. The endodermis also prevents solutes that have been accumulated in the xylem sap from leaking back into the soil solution. The structure of the endodermis and its strategic location in the root fit its function as sentry of the border between the cortex and the vascular cylinder, a function that contributes to the ability of roots to transport certain minerals preferentially from the soil into the xylem.

7. Controlling the route of water in root
Endodermis
cell layer surrounding vascular cylinder of root
lined with impermeable Casparian strip
forces fluid through selective cell membrane
filtered & forced into xylem cells
Aaaah…
Structure–Function yet again!

8. Root anatomy
dicot
monocot

9. Mycorrhizae increase absorption
Symbiotic relationship between fungi & plant
symbiotic fungi greatly increases surface area for absorption of water & minerals
increases volume of soil reached by plant
increases transport to host plant

10. Mycorrhizae
The hyphae of mycorrhizal fungi extend into soil, where their large surface area and efficient absorption enable them to obtain mineral nutrients, even if these are in short supply or are relatively immobile. Mycorrhizal fungi seem to be particularly important for absorption of phosphorus, a poorly mobile element, and a proportion of the phosphate that they absorb has been shown to be passed to the plant.

11. Transport of sugars in phloem
Loading of sucrose into phloem
flow through cells via plasmodesmata
proton pumps
cotransport of sucrose into cells down proton gradient

12. Pressure flow in phloem
Mass flow hypothesis
“source to sink” flow
direction of transport in phloem is dependent on plant’s needs
phloem loading
active transport of sucrose into phloem
increased sucrose concentration decreases H2O potential
water flows in from xylem cells
increase in pressure due to increase in H2O causes flow
can flow 1m/hr
In contrast to the unidirectional transport of xylem sap from roots to leaves, the direction that phloem sap travels is variable. However, sieve tubes always carry sugars from a sugar source to a sugar sink. A sugar source is a plant organ that is a net producer of sugar, by photosynthesis or by breakdown of starch. Mature leaves are the primary sugar sources. A sugar sink is an organ that is a net consumer or storer of sugar. Growing roots, buds, stems, and fruits are sugar sinks. A storage organ, such as a tuber or a bulb, may be a source or a sink, depending on the season. When stockpiling carbohydrates in the summer, it is a sugar sink. After breaking dormancy in the spring, it is a source as its starch is broken down to sugar, which is carried to the growing tips of the plant.
A sugar sink usually receives sugar from the nearest sources. Upper leaves on a branch may send sugar to the growing shoot tip, whereas lower leaves export sugar to roots. A growing fruit may monopolize sugar sources around it. For each sieve tube, the direction of transport depends on the locations of the source and sink connected by that tube. Therefore, neighboring tubes may carry sap in opposite directions. Direction of flow may also vary by season or developmental stage of the plant.
On a plant… What’s a source…What’s a sink?

13. Experimentation Testing pressure flow hypothesis
using aphids to measure sap flow & sugar concentration along plant stem
Pressure Flow: The Mechanism of Translocation in Angiosperms
Phloem sap flows from source to sink at rates as great as 1 m/hr, much too fast to be accounted for by either diffusion or cytoplasmic streaming. In studying angiosperms, researchers have concluded that sap moves through a sieve tube by bulk flow driven by positive pressure (thus the synonym pressure flow.
The building of pressure at the source end and reduction of that pressure at the sink end cause water to flow from source to sink, carrying the sugar along. Xylem recycles the water from sink to source.
The pressure flow hypothesis explains why phloem sap always flows from source to sink.

14. Maple sugaring

15. Don’t get mad… Get answers!! Ask Questions!

16. Ghosts of Lectures Past (storage)

17. Endodermis & Casparian strip

18. water moves into guard cells water moves out of guard cells
Control of Stomates
Epidermal cell
Guard cell
Chloroplasts
Nucleus
Uptake of K+ ions by guard cells
proton pumps
water enters by osmosis
guard cells become turgid
Loss of K+ ions by guard cells
water leaves by osmosis
guard cells become flaccid K+ K+
H2O
H2O
H2O
H2O K+ K+ K+ K+
H2O
H2O
H2O
H2O K+ K+
Thickened inner
cell wall (rigid)
H2O
H2O
H2O
H2O K+ K+ K+ K+
Stoma open
Stoma closed
water moves into guard cells
water moves out of guard cells

19. Control of transpiration
Balancing stomate function
always a compromise between photosynthesis & transpiration
leaf may transpire more than its weight in water in a day…this loss must be balanced with plant’s need for CO2 for photosynthesis