1. T400 Motor Replacement

2. Tools Require Phillips screw driver 2mm, 8mm hex screw driver
17mm,19mm ,32mm wrench
Adjustable wrench

3. Remove blade Remove arbor bolt (Figure 1) to remove blade
Figure 1: Arbor flange and bolt

4. Arbor Flange
Remove inside flange from shroud by removing set screw at the bottom of the shroud.
Figure 2: Arbor flange and set screw

5. Remove shroud
-Pull off inside flange and unscrew the four bolts on the shroud
-Then disconnect the hoses from the top of the shroud
Figure 3: Shroud Water line

6. Remove Belt
Loosen four bolts that hold motor to remove belt, then loosen the
set screw and pull off the pulley (Figure 4)
Figure 4: T400 belt Motor roller

7. Motor Bolts -Remove 4 bolts that hold motor (front and back)
-Remove motor wire connectors
Figure 5: Motor bolts Power connector

8. T400 Motor -Level motor mounting table and lock the feed handle
-Pull out motor
Figure 6: T400 motor

9. Replace Roller and Belt
Set new motor in place
Install motor drive wheel and belt
Figure 7: T400 drive wheel T400 belt

10. Power connector
Reconnect power cables according to diagram on back of the cover
Replace cover and tighten screws
Figure 8: Motor bolts Power connector

11. Motor shroud Slide on the shroud and tighten the four screws
Reconnect hoses on the top of the shroud
Figure 9: Shroud Water line

12. Aligning Inside Flange
Reinsert arbor flange. Then tighten the arbor blade and bolt before reinserting set screw inside flange
Figure 10: Arbor flange Arbor blade

13. Inside Flange Tighten the set screw that holds the inside flange
Figure 11: Set screw hold the flange