1. Replacement of outside mirror
for old Rexton model
January 15, 2018
Export Parts Team

2. ■ Replacement of outside mirror
1.Back Ground
January 4th 2018
- The previous supplier stopped providing O/S mirror of old Rexton model (~May 24, 2012)
Old(~12M/Y)
New(Modified)
Turn signal lamp circuit removed & color painted around lens
2.Supply plan
Supply LH/RH SET Only at the beginning → Later, supply LH/RH side separately
Turn signal lamp removed and color painted around lens on modified mirror(Y290)
Extension wiring enclosed in packing box for connection
Separately supply depending on –MEMORY / +MEMORY spec
Color option (4): WAA, LAK, SAF, NON-PAINT

3. ■ Replacement of outside mirror
3.Installation difference
Old(~12M/Y)
NUT installed
(screw the bolt) 60
62.5 90
New(Modified)
BOLT installed
(screw the nut) 60 96
126
BOLT: D
NUT:
4. How to install
1. Mark the crossing point of extended lines connecting lower and upper holes (126mm, 96mm) on the front door panel
- Measure with a steel ruler
- Need to drill UPPER HOLE ONLY; lower holes no change
2. Drill a hole Ø7mm
- Drill a hole wider around 7~9mm to match mirror and panel
3. Assemble the pieces of extension wiring
4. Carefully take a look if extension wiring is squashed
by O/S mirror while installing
96mm
(center line)
Ø7mm
Ø7mm
126mm
(center line)

4. ■ Replacement of outside mirror
5.Old & New Part number

5. ■ Replacement of outside mirror
6.Socket PIN array of replacement
**Manual folding O/S Mirror : Need to cut or modify the new wiring **
CONTROL UP/DOWN
CONTROL E(-)
CONTROL LEFT/RIGHT
MEMORY LEFT/RIGHT
MEMORY UP/DOWN
MEMORY B(+)
HEATER(No polarity)
FOLDING B(+)
FOLDING E(-)
MEMORY E(-)