1. Communicate with an NA through the NX102
Routing - NX102
Communicate with an NA through the NX102

2. Warning
In order to work with this document, the user is expected to have basic Sysmac knowledge.
This quick start instruction has been compiled with great care, but we can not guarantee that the information in this document is correct and complete.
If in doubt, consult the recommended manuals and / or datasheets.
If you find an imperfection in one of our quick start instructions, please report this via our helpdesk at so that we can improve this.

3. Minimum Required Software Qty Part Number Description 1 SYSMAC-SE200D
Sysmac Studio DVD (v1.23 or newer)
SYSMAC-SE201L
Sysmac Studio single license
Hardware NX
All NX102 CPU’s are possible
NA5-12W101
All NA HMI’s are possible 2
Ethernet Cable
2x RJ45, all lengths <100 m
CP1W-CN221
USB cable 1.8 m A-type to B-type
S8VK-S06024
24 VDC, 60 W power supply
Documentation
Code
W506
CPU Unit Built-in EtherNet/IP Port User Manual

4. Wiring diagram PC with Sysmac Studio NX102-1100 IP:192.168.250.15
GW:
NA5-12W101
EtherNet Cable
USB cable
IP:
IP:
S8VK-S06024
IP:
GW:

5. Setup PC
Open the settings for the Ethernet connection that is being used
Possibly close all other connections
Set the IP address
For this example, the following IP addresses are used:
IP: subnet:
Default Gateway:
Note: Windows can have multiple Default gateways. By default all data will go through the first Default gateway or via the port with the highest priority. Turn off all other connections (including Wi-Fi) or remove the cable.

6. Setup NX102 Open Sysmac Studio and select new Project
Start with a new Controller type NX102-xxxx
Open Controller Setup in the Multiview Explorer
Select Build-in Ethernet / IP Port Settings

7. Setup NX102 Set the IP addresses
For this example the default IP addresses are used:
Port 1: subnet:
Port 2: subnet:
Set the IP Forward to Use(default setting)
Scroll down

8. Setup NX102 Go online with the controller
If necessary, set the communication settings correctly via the Controller Communication setup
Synchronize the project with the controller

9. Setup NA "Add" an NA HMI in the existing project
Choose the NA in the Multiview Explorer

10. Setup NA Open HMI Settings in the Multiview Explorer
Select TCP/IP Settings
Set the IP address
For this example, the following IP addresses are used:
IP: subnet:
Default Gateway:

11. Setup NA Go online with the HMI via USB
If necessary, adjust the communication settings via HMI - Communication Setup
Synchronize the project with the NA

12. Online NA
Disconnect the NA if it is still open (USB) and remove the USB cable
Fill in IP address, subnet and default gateway via the HMI
Set the communication settings to the next setting via Controller Communication Setup
Ethernet Connection via a hub
IP adres
Go Online
If it does not work, check Default
gateways on the PC eg via CMD + ipconfig
Test does not always work in this case