Presentation is loading. Please wait.

Presentation is loading. Please wait.

عضو هیات علمی گروه بهداشت حرفه ای دانشگاه علوم پزشکی کاشان

Similar presentations


Presentation on theme: "عضو هیات علمی گروه بهداشت حرفه ای دانشگاه علوم پزشکی کاشان"— Presentation transcript:

1 عضو هیات علمی گروه بهداشت حرفه ای دانشگاه علوم پزشکی کاشان
بنام خدا عباس بهرامی عضو هیات علمی گروه بهداشت حرفه ای دانشکده بهداشت دانشگاه علوم پزشکی کاشان

2

3 در پایان جلسه دانشجوباید بتواند :
1- اساس جذب اتمی را شرح دهد. 2- اجزاء دستگاه جذب اتمی شعله ای را بیان کند. 3- مهمترین تفاوت بین اسپکتروفوتومتر و جذب اتمی را بیان کند. 4- مهمترین عیب دستگاه جذب اتمی را شرح دهد. 5- انواع سوخت و کمک سوخت مورد استفاده در دستگاه جذب اتمی شعله ای را بیان کند.

4 Introduction Flame atomic absorption is a very common technique for detecting metals and metalloids in environmental samples. It is very reliable and simple to use. Figure 1 shows which elements are commonly detected through atomic absorption. The technique is based on the fact that ground state metals absorb light at specific wavelenths. Metal ions in a solution are converted to atomic state by means of a flame. Light of the appropriate wavelength is supplied and the amount of light absorbed can be measured against a standard curve

5

6 جذب اتمي Atomic Absoption
در جذب اتمي نمونه توسط حرارت اشعه ، جرقه ، كوره و..... به صورت اتم هاي گازي در مي آيد سپس با عبور يك نور از داخل اين گاز اتمي در طول موجي كه با انتقال از يك سطح به سطح ديگر هم پوشاني نمي كند تهيج صورت مي گيرد شدت جذب تابع اتم هايي است كه جذب مي كند .

7 Introduction Atomic absorption is the absorption of light by free atoms. An atomic absorption spectrophotometer is an instrument that uses this principle to analyze the concentration of metals in solution. The substances in a solution are suctioned into an excited phase where they undergo vaporization, and are broken down into small fragmented atoms by discharge, flame or plasma.

8

9 Picture of an inductively-coupled plasma atomic emission spectrometer

10

11

12 Table 1. Characteristics of different flames Source Reynolds et al
Max. temp. (oC) Max. flame speed (cm/s) 1840 55 Air-Coal gas 1925 82 Air-propane 2050 320 Air-hydrogen 2300 160 Air-50% oxygen-acetylene 2815 640 Oxygen-nitrogen-acetylene 3060 1130 Oxygen-acetylene 4640 140 Oxygen-cyanogen 2955 180 Nitrous oxide-acetylene 3095 90 Nitric oxide-acetylene 2660 150 Nitrogen dioxyde-hydrogen 2650 390 Nitrous oxide-hydrogen

13 Thank You


Download ppt "عضو هیات علمی گروه بهداشت حرفه ای دانشگاه علوم پزشکی کاشان"

Similar presentations


Ads by Google