1. Manual Downtime Entry

2. Add Machines Downtime reasons3
Will be mainly used by CEG 1
For Break Downs
the selection of the
Reason is a must 2
Adding and removing
Reasons is an easy process
and will be done by plants

3. Add Machines Downtime reasons1
For Break Downs
the selection of the
Equipment is a must 2
Adding and removing
Equipment is an easy process
and will be done by plants

4. Add Machines Downtime reasons2
An UnitID needs to
be entered by plant
to select the right flavor
for LIS 1
Adding and removing
Flavors is an easy process
and will be done by plants

5. Add Machines Downtime reasons2
Unit ID is Read Only and the selection
Is done automatically by PLC 1
Adding and Removing
Primary Packs will be done
by Control Eng. Group

6. Add Machines Downtime reasons2
An UnitID needs to
be entered by plant
to select the right Secondary
Pack for LIS 1
Adding and removing
Secondary Pack is an easy process
and will be done by plants

7. TPM Interface – Line #1 2 3 4 5 6 7 8 1 Click here for help
Select the Start and End
Date / Time and click
Get Events
Select the type of event
that you want to focus on 4
No action required for
this section in case
of Minor Stops 5
To be filled out by the
EOD – Break Downs or Process Stop 6
To be filled out by the
EOD – Break Downs or Process Stop
Click here for help
Comments are
optional 7 8
This section to be
filled out case By case 1
This screen is for TPM data
entry and Is important to
be filled out properly

8. Reports 1 2 No action required for this section in case of Minor Stops
When we select a Minor Stop this sections become invisible

9. Reports
Select Equipment
for Break Downs
Process Stop

10. Reports
Select Reasons
for Break Downs
Process Stop

11. Reports
Select Failure Factor
for Break Downs and
Process Stop

12. Reports Select Failure Prevention case by case for Break Downs and
Process Stop

13. Reports Select Failure Prevention Status
case by case for Break Downs and
Process Stop

14. Reports Select Re-Application Status case by case for Break Downs and
Process Stop

15. Reports
Comments are
optional

16. Reports 2 3 4 1 Select the Break Down event that will be converted
to a Process Stop 3
Click on this
push button 4
After you click OK
the Break Downs
will be converted to
Process Stop 1
This is an example on
how to convert a Break Down
to a Process Stop

17. Reports
The Break Down
was converted to
Process Stop

18. Reports 2 1 The table should be empty if We can easily check
the plant personnel filled out
the information for Break Downs
We can easily check
if the information for
Break Downs was filled out