1. Standing and Running Trim
Presented by
Mike Bell
AWILL
Career & Technology Education
Module 10

2. Take Off from Floor Plan
Tally Quantity of Door Frames
Develop Parts List for Board Footage Use
Jambs, Casing, Stop
Develop Board Footage (include Waste)
FROM YESTERDAY - START OFF WITH THE QUESTIONS:
There are two aspects of these bookcases that do not meet the AWI Quality Standards for this project.
If you know what they are, save your answer for tomorrow, there may be a great prize in your future.
ANSWER: 1) Bookcase shelving needs to be 1” thick for spans over 32” - in QSI8, 400-G-8; 2) Structural lumber for toe-kick is not recommended in QSI8, 400 A-T-1.
Exercise to do the door jamb take-off from the Floor Plan drawings
Presenter instructs attendees to go to back of the handbook to find the 11_Frames & Casings Worksheet.
Enter quantity of door frames
Calculate the BF of material required
Target time = 5-6 minutes for take-off | minutes for calcs.

3. Calculate Labor Costs Scope: Jamb with Applied Stop
Casing sent loose in bundles
No pre-machining for hardware
No factory finish
Fabrication Labor Times
100
900
Turn to your Labor Sheet and look up the Cost Book codes and list.
Time: 10 mins.

4. Calculate Labor Costs for Crown and Base
Scope: Crown and Base
Reference Trim Worksheet
Fabrication Labor Times
100
900
Develop total cost of materials and
labor for your bid
Presenter instructs attendees to pull out Trim worksheet with crown and base.
Turn to your Labor Sheet and look up the Cost Book codes and list.
Time: 5 mins.

5. Summary Table Captains
Report a Consensus of Lineal Feet of Door Casing from your Table
Presenter instructs Table captains to assign a reporter to go to flip chart and place their total lineal footage.