1. SMART VEHICLE SOLUTION
FOR RELIANCE PETROLEUM –JAM NAGAR REFINERY
POWERED BY GALLER GRID
Galler India envisions a future where Men and Machines speak to each other on a common platform so as to co-exist and create an environment of efficiency and safety ,which in turn shall create a better world. Smart vehicles is a step in that direction.

2. PURPOSE
Equipment monitoring or data collection is a manual operation and dependent on the operator working on the machine. With the help of IoT techniques and RTUs, remote monitoring / analysis of equipment performance can be done and alerts generated for the critical parameters.
The Parameters can be classified under following sections:
Safety
Fuel monitoring
Maintenance & Operation data
Track & Trace

3. EQUIPMENTS TO BE MONITERED
Transit Mixer
Fork lifts
Mobile Boom Placer
Reachstaker
Concrete Pump Excavator with Rock Breaker
Vacuum Lifter Pick and Carry ( Hydra )
Dozers
Tipper Truck Trailers
Backhoe loader (JCB)
Pick up vans - 2/4/6T
Motor Grader Vibratory Rollers
Tractors
Wheel Loaders (front end loader)
Fuel dispenser
Skid Steer Loader Aerial Platform ( Manlift )
Water Tankers
Crawler Crane
Cement Bulkers
Tower crane
Tyre mounted Crane
DG Sets Lighting Mast
Air compressor

4. PARAMETERS
The followings Parameters will be monitored by the Remote Telemetric Unit (RTU):
Engine ignition status (on/off ), equipment idle time
SLI By Pass - Trigger + Data
Overload trigger at specific %
Hour meter
Over hosting Trigger
KM reading
Load Lifted data
Engine Temperature - Trigger for high temp
Operator authentication
Articulation angle for Pick & carry
Engine Oil Presssure - Trigger for low pressure
Trigger on extended teli boom below specific angle
Trigger on SLI disconnect / By pass

5. SMART VEHICLE TRANSFORMATION PROCESS

6. Suggested Communication Protocols

7. GPRS enabled Remote Telemetric Unit
Architecture
Galler Cloud
4x RS485 Input (Monitoring)
Remote Access for Configuration and Data Extraction
GPRS enabled Remote Telemetric Unit
iOTa X
Local Access for Configuration and Data Extraction
SERVER
RF READER
8x Digital Input (Monitoring)
GPS
(Web Based)
Centralized Monitoring & Control

8. iOTa X - System Layout iOTa x
SLI , HM, KM, Temperature, Fuel Sensor, Etc.
RTC
Setting Interface
Digital & Analog I/O
Keypad
iOTa x
Relay
LAN Ports
De-Bugging and Configuring
Trigger
RS232/485 RF
Bluetooth
Monitored Power to GPS and other sensors
Power Supply
Operator Auth
Authentication / Configuration

9. GPRS/LoRa enabled Remote Telemetric Unit
Data Capture Process
Non Contact Infrared Temperature Sensor Standard Modbus Support RS485 TTL
CANBUS INTERFACE
SLI
FUEL SENSOR WITH RS485 PORT
1. Read engine diagnostic data including RPM, speed, ECT, MAF, TP, odometer and fuel consumption 2. Indicate engine on and off 3. Record trip start and end time
4. Output: UART/RS232/RS485
5.Location status
PROTOCOL CONVERTOR
GPRS/LoRa enabled Remote Telemetric Unit
iOTa X
Galler Cloud

10. THANK YOU