1. Solidworks Computer-Aided Drafting Program LESSON 5-BOB
Presenter
Billy Fowler

2. Lesson 5-BOB 2D to 3D View Drawing Lines, Three point arc, Circles, Smart Dimension, Extrude and Extrude Cut

3. Sketch a Vertical Line from the Vertex

4. Use of Smart Dimension,
Set 12”

5. Use the Three Point Arc,
And click on the top and middle of line

6. Draw another three point arc, and use smart dimension and set the first Radius of 3”, and the second 3.21”

7. Insert a Circle and set the dimension at 12”

8. Insert another circle, inside the previous circle and set it 6”

9. Use the Copy Entities, to Copy the letter “B” and place it along the same plane past the letter “O”

11. Insert two lines and position the lines with Smart Dimension

13. Apply three point arcs, and set the two arcs with the following Radius

14. Set the following lines at desired dimension

15. Do the Same on the Second Letter “B”

17. Extrude @ 3” and then Extrude Cut @ 3”, also