Presentation is loading. Please wait.

Presentation is loading. Please wait.

Flo-Direct®.

Similar presentations


Presentation on theme: "Flo-Direct®."— Presentation transcript:

1 Flo-Direct®

2

3 What is the Flo-Direct®
An Instantaneous Gas Fired Hot Water Heater Direct contact of hot gases and cold water Size ranges of 1MMBTU – 300MMBTU+ Produces from 15gpm – 10,000gpm+ Temperatures up to 185 degrees The most efficient way of heating water

4 Flo-Direct® & Boiler Make-Up
99.7% Flo-Direct® & Boiler Make-Up Boiler Make-up Benefits Increase efficiency outputs up to 10% Steam & energy used to heat water is decreased High efficiency make-up water Payback calculation: 20% BTU’s used for heating make-up water is saved

5 Boiler vs. Flo-Direct® Boiler Use
High Use Idle If a sticker on a car says that the car gets 40 mpg and you drive 20 miles a day to work one way, then you should only use 1 gallon of gas a day, right? No, consider stop and go traffic, low tires, dirty fuel filter, exhaust leak, etc. Combustion efficiency is not the same as system efficiency A Boiler is much the same!

6 Hot Water Production Efficiency with Steam System
Boiler System 100% Energy In At best 80% Energy Out (Average 60%) Fuel In Hot Water Out Boiler Potential Boiler System Loss Points Inherent Boiler Loss = 15% Radiant Losses = 1% Blowdown Losses = 2.5% Steam Leaks = 3% Trap Losses = 10% Scale Losses = 10% Heat Exchange Losses = 5% Lost Condensate = 5% Air Fuel Ratio Losses = 4%

7 Why Is The Flo-Direct® So Efficient
No Loss Out The Stack No Lost Condensate No Idle Run Time No Lost Radiant Heat Hot Water On Demand 100% Energy In Fuel In 99.7%+ Energy Out Hot Water Out

8 The latest in new energy savings technology
CTE Hot Water Generator

9 CTE Technology “The New Generation of water heating”
Qualifications needed to be considered a CTE water heater. 1) Must have multiple thermal passes. 2) Must have a dry combustion chamber. 3) Must maintain complete combustion at all times. 4) Must maintain a minimum of 99.7% efficiency at all times, not just under optimal conditions. 5) Must have a Fail Safe Water Quality integrity system.

10 Advantages of CTE Water Heaters
More Efficient Same Efficiency Throughout Operation Maintains Higher Water Quality Less Co2 Emissions Lower Maintenance NO SCALE BUILD UP

11

12 New technology means New Energy Savings Opportunities
Hydronic Heating i.e.: Greenhouses, floor heating, large facilities. Re-circulating Loops. Food Ingredients (heating and de-aerating water) Water sterilization Chemical process

13 Flo-Direct® with Remote Storage Tank

14 Flo-Direct®

15

16


Download ppt "Flo-Direct®."

Similar presentations


Ads by Google