1. How to Change a Flat Tire
Representor: Yoo D. Moon
Date : November 25, 2008

2. Introduction
What you will need
Process
Tips and warning

3. What you will need Jack Lug wrench Spare tire Tire blocks (Optional)
Gloves (Optional)
Flashlight (Optional)

4. Process Step 1 : Choose your spot well
Put the car in park in a level area
Apply parking break
Put manual transmissions in gear
Turn Engine off/ turn on hazard light
Open the hood

5. Process Step 2 : Remove tools from vehicle
Wedge wheel using a solid object
Get a spare tire, lug nut wrench, and jack.
Step 3 : Loosen the lug huts
Remove the hubcap,
if necessary
Using the lug wrench, begin to
loosen the lug nuts
Do not remove the lug nuts,
only loosen them

6. Process Step 4 : Jack up the vehicle
Position the jack under the car, and raise until it contacts the frame
Position the jack on the right position
Contacts the car at a small plate
on the frame of the car
The plate is located just in
front of the rear tires, and
just behind the from tires.
Extend the jack about 6 inches off the ground

7. Process Step 5 : Remove the flat tire
Remove the lug nuts from the bolts, and put them aside
Grab the wheel
Easy way : grab the tire at the
“nine o’clock” and
“three o’clock” position
Pull the wheel straight toward you, and off the car

8. Process Step 6 : Put on the spare tire
Position the spare tire directly in front of the wheel well
Align the holes in the center of the spare tire with the bolts on the car
Lift the spare tire and position it on the threaded bolts
Push the tire onto the car until it cannot go any father
Replace the lug nuts on the bolts and tighten them, but not too tight

9. Process Step 7 : Lower the vehicle
Lower the car with the jack until the car is again resting on all four tires
Tighten the lug nuts with one, then moving to the one opposite it, and so on 1 3 5 2 4

10. Process Step 8 : Put the tools away
Place the tools and the flat tire back to the original place
Carefully inspect your work area and make sure that you are not leaving anything

11. Process
Put them all together

12. Tips and Warnings Squirt oil on the base of stuck lug nuts
Keep equipment ready
Never get under car with only a jack for support
Pull lug nuts (Don’t push)
Use knees (Not back) when using wrench