Presentation is loading. Please wait.

Presentation is loading. Please wait.

SWEDE 2011 Conference Design-Smart Grid Workshop Presented by

Similar presentations


Presentation on theme: "SWEDE 2011 Conference Design-Smart Grid Workshop Presented by"— Presentation transcript:

1 SWEDE 2011 Conference Design-Smart Grid Workshop Presented by
Frank Daniel Oncor Electric Delivery

2 Deployment Remote Control (600) and S&C IntelliTeam II (650)
Approximately 1250 switches Total Switch types ScadaMate ScadaMate cx Intellirupter PMH Vista

3 Deployment Previous installations 100-250 per year
Present installations approximately 30 CREZ Typical cost - $75,000 per switch including repeaters Normal installation is 1.5 switches per feeder

4 Deployment Capacitor controls Remotely monitored Fault Indicators 3600
SEL FCI – 6 Cooper - 3

5 Deployment Organizational responsibilities
Engineering DOTs in field handle simple task PNC techs out of WDOC handle all other aspects After CREZ will pick back up to around 250 units per year

6 Switch Specifications
Interrupting Ratings – 12.5 kA Voltage Ratings – 12.5 – 35 kV Continuous Current rating – 630 amps 800 amps for short periods Reclose Provisions – IntelliRupter only Communications L&G S&C SpeedNet Fiber

7 Mounting/Installation Requirements
Pole mounted switches ScadaMate – Class 5 wood pole IntelliRupters - Class 3 wood pole Padmounted switches only in selected applications Install at highest elevations possible East Texas taller poles for better communications

8 Maintenance Provisions
By-Pass switch – standard recloser type with isolation and by-pass IntelliRupters offer best modular approach Programming done in advance Install switch and some simple commissioning Testing S&C software for programming and trouble shooting – no in-house software

9 Safety Requirements Working line hot Working Line dead
Set hot line tag Working Line dead Visible Open required Ground line section Substation Integration Module (SIM) SIM provides load information to switches SIM takes switches out of ready for manual breaker operation, under frequency, etc

10 Non-AMI Communications
Communications in general is a mesh network with peer to peer communications Back haul is cellular modems Some sellected sites have fiber communications All switches have local control / monitoring Face plate – 5800 controls Laptop via WiFi - IntelliRupter

11 Non-AMI Communications
Collecting Data Manual Initiated for trouble shooting and reports Data includes Loads Switch operations Automatic operations Status of switch S&C software is used to connect to switches

12 Advanced Metering Initiative
More than 1.5M total meters installed through December 2010 Industry-first, customer information portal launched in 2010 – Began In-Home Monitor pilot program to 500 customers Cooperating with Texas Retail Electric Providers by interoperability testing HAN devices for their rollouts

13 AMS Communication Networks
RF Mesh Network 900 MHz Collectors Mounted on 70 ft. concrete poles Four antennas on the top, and a control panel and backhaul communication box at the base Normally located in substations, within substation fence Approximately 250 Backhaul Network Satellite, microwave, cellular, fiber, and wide area network Repeaters/Routers Mounted on utility poles and street lights Approximately 36 per collector Approximately 9,000 Back Office Advanced Meters Installed in residential and commercial premises Meter-to-meter communication Approximately 378 per repeater/router Approximately 3.4 million IT Systems In-Home Display Smart Appliances Home Area Network AMI Integration Evaluating two-way capacitor controls and FCIs AMI communications layered Takeout point Routing Meter (quazi routing) Problems Separate takeout point required Command Center for DA DA communications has priority over metering

14 Integration with OMS Future
Meters to provide last Gasp after outage Transformer Fused lateral Switching device Switches will provide sectionalization for faults Switches and meters will provide load and voltage information Planning will use info from switches to verify loads

15 Budgeting / Cost Recovery
Cost recovery at present is imbedded in rates Budgeting is based on available funds and formula applied to each request All installations have a separate code for tracking purposes

16 Oncor Substation Architecture – VLAN & VRF Tunnels
Virtual Routers Securely ties Tunnels to VLANs LAN Facing Integrated LAN Switching Hardware & Virtual LANs WAN Facing DMVPN Tunnels TMS TMS RTU DMS/AMS TMS VLAN Enterprise Authentication DMS/AMS VLAN Mesh/PLC AMS Headend Terminal Server Substation Router Enterprise Voice VLAN Enterprise Data VLAN Authentication VLAN Equipment Alarms CIP Cyber-Security Perimeter DFR Voice Data

17 Questions Short break while someone else comes up to answer questions
Sorry SOMEONE ELSE is YOU Controlled by SMART GRID


Download ppt "SWEDE 2011 Conference Design-Smart Grid Workshop Presented by"

Similar presentations


Ads by Google