1. Elastic Properties of Isolated Thick Filaments Measured by Nanofabricated Cantilevers 
Thomas Neumann, Mark Fauver, Gerald H. Pollack 
Biophysical Journal 
Volume 75, Issue 2, Pages (August 1998)
DOI: /S (98)
Copyright © 1998 The Biophysical Society Terms and Conditions

2. Figure 1
(a) Drawing of a silicon wafer with multiple windows that contain the cantilevers. The base of each window carries one calibration cantilever and five cantilever pairs of different length. (b) Window-base segment containing two cantilever pairs of different length (center, 400μm; right, 380μm). The left lever is used only for calibration and is therefore designed stiffer to exclude damping effects. Image obtained using an environmental scanning electron microscope.
Biophysical Journal  , DOI: ( /S (98) )
Copyright © 1998 The Biophysical Society Terms and Conditions

3. Figure 2 Schematic drawing of the experimental setup.
Biophysical Journal  , DOI: ( /S (98) )
Copyright © 1998 The Biophysical Society Terms and Conditions

4. Figure 3
Electron micrographs (courtesy of Dr. Károly Trombitás) taken from isolated thick filaments of Mytilus after negative staining using 1% uranyl acetate.
Biophysical Journal  , DOI: ( /S (98) )
Copyright © 1998 The Biophysical Society Terms and Conditions

5. Figure 4
Thick filament of Mytilus suspended between cantilever and reference beam. In the left column are photographs obtained using differential interference contrast microscopy. In the right column are schematic drawings illustrating corresponding stages of the experiment. Note that levers are considerably longer than shown in the photographs.
Biophysical Journal  , DOI: ( /S (98) )
Copyright © 1998 The Biophysical Society Terms and Conditions

6. Figure 5
Performance of the levers (stiffness, 0.31pN/nm). (a) Image of the two lever tips on the photodiode array. (b) Computed centroid position of each tip (traces 1 and 2). The differential signal (trace 2 minus 1) reduces noise and drift.
Biophysical Journal  , DOI: ( /S (98) )
Copyright © 1998 The Biophysical Society Terms and Conditions

7. Figure 6
Time course of length change imposed on a 15–16-μm-long Mytilus thick filament by rapid manual micromanipulator movement. Computed positions of the free cantilever (top), the cantilever with the attached filament (middle), and the reference beam (bottom) are shown. A 12-μm segment of the filament was included in the stretch, as indicated by a. This segment was extended by ∼58% (b). Data were obtained from the photodiode array.
Biophysical Journal  , DOI: ( /S (98) )
Copyright © 1998 The Biophysical Society Terms and Conditions

8. Figure 7
Results on single M. edulis thick filaments. (a) Length-tension diagram showing three successive stretch-release cycles of increasing magnitude. (b) Six successive stretch-release cycles of the same magnitude. First and last cycles are highlighted, with beginning and end points indicated by filled symbols.
Biophysical Journal  , DOI: ( /S (98) )
Copyright © 1998 The Biophysical Society Terms and Conditions

9. Figure 8
Results on single L. polyphemus thick filaments. (a) Length-tension diagram showing three successive stretch-release cycles of progressively increasing magnitude. (b) Five successive stretch-release cycles of the same magnitude. First and last cycles are highlighted, with beginning and end points indicated by filled symbols.
Biophysical Journal  , DOI: ( /S (98) )
Copyright © 1998 The Biophysical Society Terms and Conditions