1. To install the four wires from the back of the coil machine, loosen the four knobs. Insert each of the four wires from the side under the knobs. Keep each wire in center under each knob, off to the side will allow for a poor connection. Insert the two black wires under the top and bottom knobs, and the two red wires under the center knobs, either red can go under either knob and either black can go under either black knob . Finger tighten securely.

2. Note: move all MODE switches to the left except for 4 and 5 which are to the right!

3. Loosen 2nd and 3rd screws and insert “U” shaped connectors on small horseshoe wire, tighten the 2nd screw.

4. Insert green ground wire from rear of coil machine under 3rd screw over the small horseshoe wire and tighten.

5. Loosen 1st screw, insert red “L” shaped wire, and tighten screw.

6. Loosen 2nd screw enough to insert black “L” shaped wire over small horseshoe wire, and tighten screw.

7. Attach red alligator clip from the frequency generator to red “L” shaped wire under 1st screw with “+” sign. Important: Red must be attached to top screw. Attach black alligator clip from the frequency generator to the black “L” shaped wire under 2nd screw with the “-” sign. The opposite end of the black cord plugs into the frequency generator plug which says “Output 50 Ω”.

8. Congratulations, you are finished
Congratulations, you are finished. This is what your wiring will look like upon completion.

9. The speaker wire from the coil plugs into the right side of the Doug coil machine.