Download presentation
Presentation is loading. Please wait.
1
EML 2023 – Threads and Fasteners
Lecture 2 - Threads and Fasteners in SolidWorks
2
2 things to remember if you tap a hole
the thread length should be at least twice the diameter of the fastener if you use a bolt to connect some bodies the bolt should extend beyond the nut by at least two thread pitches
3
#10-24 cap screw .30” .75” minimum length was calculated as:
.19 = .68” purchased a screw that was .75” long create a countersunk clearance hole in the top part create a tapped hole in the bottom part the thread depth must be at least .45” long .30” .75”
6
2nd Example Problem 3/8” – 24 cap screw blocks are 1.5”1.5”.55”
7
2 things to remember if you tap a hole
the thread length should be at least twice the diameter of the fastener if you use a bolt to connect some bodies the bolt should extend beyond the nut by at least two thread pitches
8
Determining Bolt Length
.55
11
Bolt length calculation
Bolt must be 1.988” long plus the distance of 2 extra pitches. The bolt has 24 threads per inch. Two extra pitches will require an extra 1/12” of an inch. Total minimum length is = 2.221” . Find the next longest available bolt. .55” 2.138” .08” 21/64”
12
2 things to remember if you tap a hole
the thread length should be at least twice the diameter of the fastener if you use a bolt to connect some bodies the bolt should extend beyond the nut by at least two thread pitches
Similar presentations
© 2025 SlidePlayer.com. Inc.
All rights reserved.