1. Restoring a Gunky Perkins Brailler To Health
SESSIONS 301 & 401

2. Bottom Board removal

3. Paper Release knob?

4. Top Plate removal

5. Paper Guide removal

6. Back Plate removal

7. Carriage Lever removal

8. Remove left Apron screw, then loosen right screw

9. Lift and remove the Apron

10. Front Plate screws

11. These six nuts can fall out. Don’t lose them!

12. This Pawl needs to remain clean of oil or grease.

13. This Pawl also needs to remain clean.

14. This third Pawl also needs to be clean of oil or grease.

15. When wiping down the brailler, be careful here.

16. Put Clock Oil on these bearings

17. Put Lithium Grease on these bearings

18. Put Clock Oil on the Cam Rods

19. Oil the underside of the beam

20. Oil the Pivots on both sides of the Paper Guide

21. Oiling the chain

22. The Paper Drum Cam is here

23. This is the Cam Spring

24. There are 12 Linkage Pin points

25. Apply grease to the Grooved Rollers

26. When putting on the Back Plate, make sure this wire is under the edge of the plate!

27. Here is the Space Bar Pawl you need to check

28. The Paper Guide should go in like this

29. Thanks for being here today
Thanks for being here today! Congratulations on your Brailler Cleaning skills!