1. Body Electrical System
CHAPTER 40
Body Electrical System

2. Disabling and Enabling the SRS
28-17
Find and remove the SRS fuse. Verify by turning the key on and observing that the SRS light remains lit for at least 30 seconds. If it goes out, you did not remove the correct fuse or all of the required fuses. Make sure the wheels are steered straight ahead. Turn the key off.

3. Disabling and Enabling the SRS
28-17
Remove the negative battery cable and allow a minimum of 15 minutes to pass to let the SRS system capacitors discharge. Note any radio presets or other memory features of the vehicle that will be erased when the battery is disconnected. Do not use a memory minder or auxiliary power source!

4. Disabling and Enabling the SRS
28-17
To enable the SRS system, verify that all SRS modules, components, and connectors are installed and connected properly

5. Disabling and Enabling the SRS
28-17
Reinstall the SRS fuse.

6. Disabling and Enabling the SRS
28-17
Reconnect the negative battery terminal and tighten properly.

7. Disabling and Enabling the SRS
28-17
Without being in front of or reaching across the driver's side airbag, turn on the ignition switch and observe the SRS light. It should illuminate briefly and then go out, and stay out. If so, the SRS system should be ready to be placed back into service.