1. Course Guidelines CADCAM Academy ev5.IO
Expert Level

2. Die preparation
3 december 2018

3. Global Options
_________________________

5. Scan and Design Three Unit Bridge with bite
Create bite
____________________________

6. Scan and Design Three Unit Bridge with bite
Positioning of the model
____________________________

7. Bite registration – Create new order
_____________________ __________________________________________

8. Bite registration – Three Point Match
________________________________

9. Bite registration – Trimming the bite
__________________________________ 1. 2.

10. Bite registration – Path of insertion
Calculating Undercuts
_______________________________
Details
Optimization of the insert direction

11. Die Parameters
______________________ ______________________ ____________________________________________ ______________________

12. Coping Parameters
______________________ ______________________ ____________________________________________ ________________________________________________________________________________________

13. Bite registration – Bridge design
Freeform Designer
____________________________

14. Bite registration – Bridge design
Wax knife/Smoothing tool
________________________________________________________________________________________

15. Bite registration – Bridge design
________________________________________________________

16. Bite registration – Bridge design
Occlusal Coping function with
anatomical pontic

17. Bite registration – Bridge design
Occlusal Coping after fusion

18. Bite registration – Bridge design
Fullanatomic Surface
_______________________________________________________________________________________________________________
Reducing function
________________________________________________________________________________________________________________________

19. Bite registration – Bridge design
Design Connector
________________________________________________________________________________________________________
Subtract gingiva
________________________________________________________________________________________________________________

20. Wax Matrix – Set up
Wax matrix
________________________________

21. Wax Matrix – Create new order
__________________________

22. Wax Matrix - Design Design
__________________________________________________________________________________________________________________________________________

23. Undercut Bridge
__________________________

24. Attachments Primary Part
_______________________ _______________________ _______________________

25. Attachments Create Order – Secondary Part
_______________________ ___________________________________________________________________________________________________________________

26. Attachments Inlaydefinition
________________________________________________________________________________________________
Design

27. Telescoping Crown Single path of insertion
________________________ ________________________ ________________________________________________
Telescoping crown design
________________________________________________________________________________________________

28. Separate Order Separate order
________________________________________________________________________________________________________________________________________________

29. Unsectioned Model
___________________________________________________________________________________________________________________

30. IPS e.max® CAD restorations by Straumann® CADCAM
If the recommended minimum thickness of your object is below the material specification during the finalization process you will be adviced trough an info box, and the object will be marked in the affected areas.
Yes -> manually correction
No -> finalize anyway
Modeling
__________________________

31. IPS e.max® CAD restorations by Straumann® CADCAM
Positioning
__________________________

32. Individual CAD Abutment
Master model and segments
________________________________________________________________________________________________________________

33. Individual CAD Abutment
Master model and segments
____________________________________________________________________________________________________________________

34. Individual CAD Abutment
Create Order
________________________________________________________________________________________________________

35. Individual CAD Abutment
Positioning
______________________________________________________________________________________________________

36. Individual CAD Abutment
Design of the meso structure
________________________________________________________________________________________________ ________________________________

37. Individual CAD Abutment
2D slice view
________________________________________________________________________________________________ ________________________
Emergence profile definition
________________________________________________________________________________________________ ________________________

38. Individual CAD Abutment
Reduced tooth form
________________________________________________________________________________________________ ________________________________

39. Individual CAD Abutment
Finalization CAD Abutment
____________________________________________________________________________________________________________________________________________________________________

40. IO Download Manager (Import of itero Data)
Create InBox - Login
____________________________________________________________________________________________________________
The IO-Login is provided by your support team!

41. IO Download Manager (Import of itero Data)
________________________________________________________________________________________

42. IO Download Manager (Import of itero Data)
____________________________________________________________________________________

43. IO Download Manager (Import of itero Data)
________________________________________________________________________________

44. IO Download Manager (Import of itero Data)
___________________________________________________________________________

45. Contact informations
Straumann CADCAM
Fabriksgatan 13
Göteborg
Tel. Support med delad skärmfunktion:
Please change address (local subsidiary)!!!