1. 1. New Assembly
2. If Top Plate is on the list,
double-click on it.
If not, Browse for it.
3. Click anywhere on the screen
to place the Top Plate
4. Assembly Tab
Insert Components
1 Axle, 2 Axle Supports,
and 1 Caster Wheel
5. Assembly tab
Rotate/Move Axle Support over Top Plate as shown.
Leave space between the parts.

2. Click the bottom of the Axle Support Then click top of the Top Plate
6. Mate
Click the bottom of the Axle Support
Then click top of the Top Plate
(see blue areas with red Xs)
Click the Green checkmark
on the floating toolbar.
REMEMBER TO DO THIS AFTER EVERY MATE
9. Repeat the same Mates
for the other Axle Support
8. Mate inside of both top and bottom holes
Do the same to the other holes. X

3. X
11. Mate X
Mate for
Caster Wheel and Axle

4. after finishing all mates. Drawing on next slide
14. Click green check mark
after finishing all mates.
Drawing on next slide
12. Mate
13. Mate

5. No dimensions
Shade with Lines – All views