1. ActivRACTM 30P Mobilized Storage System

2. Capabilities ActivRAC® 30P Mobilized Storage System
Wt. Capacity 30,000 lbs per rack section, 60,000 lbs back to back racking
Can utilize existing racking
Requires structural footings under rails. To be determined by licensed structural engineer
System requires rails to be leveled and floor finished flush to rail
Carriage design capability permits virtually unlimited carriage layout configurations
Heights – Base height to width ratio up to 4 to 1

3. Applications ActivRAC® 30P Mobilized Storage System

4. Guide Rail ActivRAC® 30P Mobilized Storage System
Welded steel two piece structural rail
2.5” square steel bar with center groove machined
6” wide x ½” thick base
Center flange guidance-minimum two guide rails
Rails to be set level and welded to top plates anchored to floor or footings with threaded rods or J-bolts

5. Guide Rail Footings ActivRAC® 30P Mobilized Storage System

6. Guide Rail On Top of Existing Structural Slab ActivRAC® 30P Mobilized Storage System

7. Load Rail ActivRAC® 30P Mobilized Storage System
Welded steel two piece structural rail
2.5” square steel bar
6” wide x ½” thick base
Rails to be set level and welded to top plates anchored to floor or footings with threaded rods or J-bolts.

8. Load Rail Footings ActivRAC® 30P Mobilized Storage System

9. Load Rail On Top of Existing Structural Slab ActivRAC® 30P Mobilized Storage System

10. Wheel Guide & Load ActivRAC® 30P Mobilized Storage System
Large 10 5/8” diameter load and drive wheels
Precision machined solid steel wheels
Each wheel has two permanently lubricated and shielded radial ball bearings

11. Carriage Base ActivRAC® 30P Mobilized Storage System
Welded Wheel Assemblies
Bolted structural steel construction
Welded Uniframe wheel assemblies
Integral rack beams
Integral cross bracing
Wire raceway and cover
Powder-coat painted finish
Integral Rack Beams
Cross Bracing
Wiring Raceway

12. Multiple Synchronized Motors ActivRAC® 30P Mobilized Storage System
Provides smooth and even carriage movement
¼ HP 90 volt DC gearmotor
Multiple synchronized motors adapt to un-level floor conditions and un-balanced loading
Continuous closed loop motor feedback system monitors all motors
Direct chain drive
2.6” per second carriage speed
Multiple Synchronized Motors

13. Control Box & Operational Interface ActivRAC® 30P Mobilized Storage System
All control boards located in the front control box for easy access for service
Open an aisle with one-touch directional control button or an infrared remote control aboard a fork truck
Safety Stop/Reset button immediately stops any moving carriage(s)
System operational status lighted indicators
Flashing beacon and horn warns of carriage movement

14. Safety System - Photo Sweep ActivRAC® 30P Mobilized Storage System
Photo sweep extends the entire length of both sides of the carriage
Stops movement of system and requires manual reset when the beam is broken in a closing aisle
Add Red Line
Photo Sweep

15. Safety System - Aisle Entry
ActivRAC® 30P Mobilized Storage System
Automatically stops and prevents carriage movement when entering a closing aisle
Manual reset at open aisle provides additional safety by prompting users to visually check the open aisle before resetting the system
Does not stop carriage(s) movement when entering an open aisle
Add Red Line
Aisle Entry Sensor

16. Optional Features ActivRAC® 30P Mobilized Storage System
Infrared remote control – user key
Requires a manual reset and visual check of open aisle for operation
Infrared remote control – managerial key
Rechargeable battery pack - Half Speed - Manual “push and hold” power operation - Approx. _ hours of operation
Can interface with inventory control systems (ERP/WMS) provides by third party
Available on 16P and 30P