1. Which design do you recommended? Customer prefers to the single node.
Single Node(front only)
Double Node(front and back)
To Control Board IC
To Control Board IC
Active Area
Transparent electrode(Not ITO)
(700ohm/sq)
Transparent electrode(Not ITO)
(700ohm/sq)
[Questions]
Which design do you recommended? Customer prefers to the single node.
With respect to the double node design, customer expects both nodes will be shorted. If you recommend this design, can you advise where should these shorted? Shorted on the sensor sheet, or shorted on the PCB(Not shorted on the sensor sheet)?
2016/8/4

2. Transparent electrode
Single side
Front Only
Transparent electrode
Line
Base
Double/Dual? Side
(Front and Back)
2016/8/4